DEVAISE ALRY009 User manual

Fabric Single Motor Lift Chair
ALRY009
www.devaise.com
DEV
V
ISE
V3.0

The lift chair is wet.
Your hands are wet.
Do not clean the chair with a wet cloth.
Safety Rules
Usage:
Never place the lift chair near a heat source (oven, chimney, fernace etc...)
or in direct sunlight.
Switch the lift chair if any part of the lift chai r is damaged or
malfunctioning, if any part of the lift
chair appears to be
damaged or wiring is exposed.
Never set the lift chair in wet / damp areas or whe re dust can accumulate
because these could cause an electrical fault or a mechanical dysfunction.
Never use the lift chair inside your home if the room temperature is
over 120°F.
Do Not use the armchair if:
Situations where you should not use the lift chair:
Never sit on the remote or place heavy objects on top of it.
Indoors, avoid high temperatures and wet or damp areas.
Do not drop the remote on the floor.
Do not tug on the electric able.
Do not use the remote with wet fingers.
Do not press or touch the buttons with sharp objects.
Never unplug the remote wihout first turning the power off.
The lift chair should rest for 30 minutes after it has been used for 30
minutes.
1
Precaution:

Can't massage
Power cord problem, please make sure the indicator lit.
Remote control problem, please make sure the indicator lit.
Please check this manual and make sure power cord and remote control
connect to the right wire (there are 2 wires need to be connected).
The wires inside the chair is damaged, which we check every chair before
shipped out to make sure it's ok.
Check that you have the right voltage.
Never use force on the cable or plug.
Never pull the cable with wet hands.
When removing the plug, hold the plug, do not pull on the cable.
Do not use the lift chair system if either the cable or the plug are
damaged.
If the lift chair is not working, check the following chart.
Make sure you turn the power off and unplug from the wall outlet.
If you have any questions, please contact us.
Problems and solutions
The lift chair does not function when the button on the
control unit is activated
Check that the plug is pushed into the wall oultlet properly.
Troubleshooting
Do not disassemble the lift chair:
Do not remove the back of the lift chair .
Do not try to disassemble or repair the lift chair yourself.
Tampering with the lift chair will void your warranty.
Correct way to handle the electrical plug:
Check whether the power supply button is on.
2

A. B.
×1 ×1
×1
Chair base Backrest
C.
×1
Armrests
D. E.
Supplies
F. G. H.
+
-
15
30
1
2
3
4
5
6
7
8
DEV
V
ISE
CL
CR
Assembly Parts
3
If you have any further questions, please feel free to contact us
by email or official website: [email protected]
We will reply ASAP.
Enjoy your new purchase!
Before installation, please make sure you have all the hardware,
the serial numbers are properly labeled corresponging to the list,
and the quantity is correct.

Position the armsrests
Position the backrest
Put the back fits into the seat,
you will hear a "click" when
it is in place.
Put the armrests fit into the seat, you will hear a "click" when they are in place.
DEV
V
ISE
A
B
CL
CR
1
2
4

Connect the supply cable pins
No.1 wire connects with part E.
No.2 wire connects with part D.
Fits the pins properly in the manner
shown in the im
age.
Do not force them,
they only have one correct position.
+
-
15
30
1
2
3
4
5
6
7
8
DEV
V
ISE
D
F
G
E
3
1
2
5

The pins must be connected correctly.
Warning!
If that should happen, turn the power off and reconnect the pins.
If the lift chair doesn't work when you finally turn it on, it is because the pins
have been connected incorrectly.
Push
Lock
DEV
V
ISE
H
6

77
2. Please press the button , the legrest will move down, at the same time,
backrest will raise up. If you keep pressing the button, the lift chair will rise up
and forward until it elevates you a standing position.
MODE
Tapping
Rolling
Kneading
1
2
3
4
5
6
7
8
Pulse
Press
Wave
Auto
Normal
How to use massage remote control?
1. Please keep pressing the button , the lift chair will return
from staning position to sitting postion. If you keep pressing
the button, the legrest will rise up, at the same time, backrest
will move down.
DEV
V
ISE
Instruction of Remote Control