
Read all of these installation instructions before installing the fixture. These
products may represent a possible shock or fire hazard if improperly installed
or attached in any way. Products should be installed by a qualified electrician
in accordance with these instructions, current local electrical code or the
current National Electric Code (NEC).
1. This product must be installed by a person familiar with the construction
and operation of the product and the hazards involved, and in accordance
with current electrical codes and/or the current National Electric Code (NEC).
2. To reduce the possibility of electric shock, fixture must be grounded.
3. Do not attempt to open the LED light engine.
4. Do not look directly into fixture.
5. Fixture is equipped with 120 VOLT Driver ONLY.
WARNING:
Handling the coated electrical wires of this product could expose you to
chemicals including lead, which is known to the State of California to cause
cancer and/or birth defects or other reproductive harm. For more information
go to www. P65Warnings.ca.gov.
WARNING: PROPOSITION 65
1. Before installation, please cut off the power.
2. Remove old fixture if necessary for installation.
3. Connect line voltage (hot) AC supply wire(s) (Black) to the line voltage AC
wire(s) (Black) inside the canopy using the wire connector.
4. Connect neutral (common) AC supply wire(s) (White) to the neutral AC
wire(s) (White) inside the canopy using the wire connector.
5. Connect the grounded AC supply wire(s) [Green or bare wire(s)] to the
grounded AC wire(s) [bare copper wire(s)] using the wire connector.
6. Cap and insulate all unused leads.
7. To aim the light, loosen the side bolt connected to the knuckle arm to aim
the fixture up or down. Fasten bolt to secure the fixture in the desired
position.
INSTRUCTIONS:
01