
3
Insert the M5 x 10 screw through the big
bumper washer and front bumper. Then attach
the front bumper to the bumper support
bracket. Secure the bumper with the M5 x 1
washer and tighten with the M5 hex nut.
Remove all parts from the support
axle and insert it through the back hole
underneath the vehicle. Then insert the
black column, washer x 1, nut x 1 and
the spare back wheel. Secure the wheel
with the M12 washer and M12 dome
head nut. Put the wheel hub cap on by
bending down the three tabs.
INSTALLATION INSTRUCTIONS
1
Attach the steering wheel to the steering
column. Put the M12 washer on the column
and screw on the M12 dome head nut.
Tighten with a wrench or spaner.
2
Open the battery compartment lid
(located in front of the pedals) and
insert 2 x 1.5V “D” batteries. Close
the lid and lock with the two nuts.
Push the headlight power button on
the dashboard to turn the headlights
on and press again to turn off.
3
4
headlight
power switch battery box is located
in front of the pedals. 1.5V x 2
“D” Battery
Do not mix old and new
batteries or batteries of
different types: alkaline,
standard (carbon-zinc) or
rechargeable nickel-cadium).
SpareWheelHole