DH Instruments PPC User manual

PPC is a trademark, registered and otherwise, of DH Instruments, Inc.
Document 560030c 031117
DH Instruments, Inc.
4765 East Beautiful Lane
Phoenix AZ 85044-5318
USA
Tel [phone]
Fax [phone]
[email protected]
www.dhinstruments.com
PPC™
Rack Mount Kit
P/N 400440
Installation Instructions
RACK MOUNT KIT, P/N 400440, INCLUDES
QTY PART NO
FIGURE
CALLOUT DESCRIPTION
1 123698 1 Front panel
2 123700 2 Side bracket
10 100972-Z 3 M4 hex nut
10 102668-Z 4 M4 split lock washer
10 100918-Z 5 M4 flat washer
1 123702 6 Rear support bracket
1 123765 7 Foam gasket
INSTALLATION INSTRUCTIONS
Place one side bracket (2) on each side of the PPC™.
Position each bracket with the front panel
attachment flange (flange with three holes) facing
the front of the PPC.
Attach the front panel (1) to the side brackets (2)
using six M4 flat washers (5), six M4 split
lock washers (4) and six M4 hex nuts (3).
Recommended torque is 3 Nm.
 Remove adhesive backing from foam strip (7).
Adhere the foam strip to the rear support bracket
(6), centering the foam as shown in figure 2.
 Attach the rear support bracket (6) to the side
brackets (2) using four M4 flat washers (5), four
M4 split lock washers (4) and four M4 hex nuts
(3). Recommended torque is 3 Nm.
 For adequate support of the PPC, the rear support
bracket (6) shall be supported on the side rails of
the rack system or by other means.
Figure 1 Rack Mount Kit
Figure 2 Rear Support Bracket and Foam