Diamond Antenna K400 User manual

Installing the K400
The K400 can be installed on trunk lid, door or hatchback. Install the bracket on desired location as shown in the
following photos.
Trunk Lid • Installing on trunk lid
The K400 bracket is basically installed as shown in
the following figure. To avoid damaging car body, use
protection plate.
bracket
car body
protection plate
set screw hexagonal wrench (small)
Use set screws attached to install the bracket.
Hatchback or Door • Installing on hatchback
Install the bracket on hatchback as shown in the above
figure with set screws and small hexagonal wrench.
To avoid damaging the car body, insert protection plate
into the place where set screws and the body contact.

Tilt angle adjustment of the
K400 bracket
1) Remove socket bolt with large
hexagonal wrench.
loosen bottom
screw antenna mounting
section
2) Remove antenna mounting section
of the bracket, and rotate it as shown
in the gure. Loosen bottom screw
with large hexagonal wrench.
3) Rebuild antenna mounting section
as shown in the gure, and adjust
tilt angle to make the antenna vertical.
K400 Parts List
K400 Grounding
Rubber protection cap
Protection plate
Set screws (short)
Trunk lid, hatchback mount bracket
Hexagonal wrench (small)
Hexagonal wrench (large)
K400 Series Mounts
K400 series mounts may be grounded by trimming
1/2” from the aluminum reinforcement strip supplied
with mount. Outside two set screws to ground.
K400 Mount Only
K400C UHF base w/6.5 ft. RG316 teon
coax & PL259
K400CNMO NMO base w/6.5 ft. RG316 teon
coax & PL259
K400-3/8C 3/8 24 base w/6.5 ft. RG316 teon
coax & PL259
DIAMOND ANTENNA Products are distributed by RF PARTS COMPANY
435 S. Pacic S treet San Marcos, CA 920 78 [phone]
www.diamondantenna.net