digi-tech WAC1705 User manual

3Input HDMI Switcher
User manual

1
I. Introduction
This is a high performance 3 HDMI input and 1 HDMI output switch. It supports HDCP repeater
functions and fast switching between any of the HDMI input ports. The system supports all 3D
TV formats in addition to all HDTV formats up to 4Kx2K. Furthermore, the remote control
gives uses complete control over the selection of sources and makes the device incredibly user
friendly. Low consumption, does not require an external power supply for normal functions.
II. Features
Compliant with HDMI 1.4a, CTS 1.4a, DVI 1.0 standards.
HDMI 1.4 support: 3D TV support.
Support 3D Video & 4Kx2K, 8, 10, 12 & 16 bits per color depth.
Audio support:
Dolby TrueHD
DTS-HD Master Audio 7.1CH

2
III. Package
3 x 1 HDMI 1.4 Switcher
Remote control
IR Receive Extend cable
Operation Manual
IV. Specifications
Frequency Bandwidth 2.97Gbps
Input Ports 3 HDMI Sockets, IR Receiver socket
Output port 1 HDMI Socket
HDMI Audio Output PCM2, 5.1, 7.1CH, Dolby 5.1, DTS5.1, D-TrueHD, DTS-HD
ESD Protection Human Body Model: ± 8kV (air-gap discharge)
± 4kV (contact discharge)
Dimensions (mm) 87(D) x59.5 (W) x 19(H)

3
V. 3×1 Switch Operation controls and Functions
Top Panel:①Switch button; Press this button to select any sources, i.e. Blu-ray, Game
Console, Set Top Box, etc, which is connected to the input and indicated by the number of the
input, i.e. ②③④

4
Front Panel：Connect the output of the switcher to a monitor or HDTV that is equipped with a
HDMI socket. The selected source will be displayed from this output.
Rear Panel：3 HDMI inputs located on the rear of the device. Connect a HDMI source to any of
these inputs.

5
Right Panel:
①DC 5V input port; this switcher does not require power to switch between the 3 available
sources. The power input is available in cases where one or all HDMI leads is or exceeds 5
metres in length.
②IR receiver port: connect the supplied IR receiver cable to receive a remote signal.

6
VI. Application Example（3×1 Switch）

7
VII. Remote control
IN1、IN2、IN3：Press any of the “IN”put numbered buttons and the
LED will indicate the corresponding selected input source.
：Press this button to cycle through the available input source
and the LED will indicate the corresponding input source.