DINGO A-025 User manual

Dingo A-025
User’s Manual
The reathalyzer D ingo A-025 analyzes a breath sample to detect alcohol in the lungs.
This reading is then converted to blood alcohol concentration ( AC). The reathalyzer
D ingo A-025 is very convenient and portable, and uses mouthpieces to concentrate the
breath sample for high precision results.
Power Button
Digital LED Display
Mouthpiece
http://www.kupi-alkotester.ru

Operation:
1. Power On/Off. Ensure two AA batteries (included) are installed by opening the
rear cover of the unit. Press the POWER button on the face of the unit.
IMPORTANT: W en you power on t e unit, you will see a countdown in t e
display. T e device must “warm up” t e sensor for testing. Please wait
until t e display s ows “0” before using t e device. T e warm up process
takes less t an 30 seconds. T e unit will play two (2) s ort BEEPS w en it is
ready for use.
2. Breat Sample. Attach a mouthpiece to the slot above the display. The user
should take a deep breath and exhale sharply and steadily into the mouthpiece for
at least 2 full seconds.
a. After you blow into the unit, it will EEP once to show that it has taken
a reading.
b. The unit will EEP again when it starts analyzing the sample. You will also
see a “WAIT” indicator flashing in the display.
c. When the analysis is complete, the “WAIT” indicator will turn off and the unit
will EEP again. You will then see a lood Alcohol Concentration ( AC)
reading in the display.
d. If a sample is not taken within 20 seconds, you will hear four (4) beeps and
the unit will shut itself off. (You can also press the POWER button again to
manually shut off the unit.)
3. Analysis and Display. Once the sample is analyzed, t e unit will display t e
result as a percent measure of Blood Alco ol Concentration (BAC) from
0.00% to 0.40%. The AC will be displayed for 15 seconds. The unit will shut
itself off after testing.
If you would like to perform another test, please power on the unit again. When
performing multiple tests, the warm up cycle shortens to less than 20 seconds.

4. Results. The legal limit for intoxication (DUI/DWI) is 0.08% AC across most of
the USA. According to the American Medical Association (AMA), a AC of 0 . 05 %
is enough to impair the ability to drive. You should never operate a motor vehicle
w h e n y o u a r e i m p a i r e d b y t h e c o n s u m p t i o n o f a l c o h o l , d r u g s o r l a c k o f p r o p e r r e s t .
Me asu re d B AC
0.00% to 0.01% Safe range. Lit tle/no a lcohol in t a k e .
0.02% to 0.04% Moderate
*
range. Increased alcohol intake.
0.05% to 0.07% Warning
*
range. Ability to drive may be impaired.
0.08% and over High Risk* range. Legal driving limit for AC
exceeded.
*
Drinking alcohol in ANY amount may impair the ability to drive. There is no “safe
level of alcohol intake before driving. Don’t drink and drive.
5. Warnings.
a. Wait at least 20 minutes after eating or drinking before testing. Alcohol
remaining in the mouth, or even excess saliva, may interfere with testing.
This includes alcohol-based mouthwash or similar products. T is is t e
most common cause of improper use and incorrect results.
b. Avoid testing in high wind or enclosed spaces. Poor ventilation may also
lengthen the time required for warm up between tests.
c. Do not blow smoke, saliva or other contaminants into the mouthpiece, as
the sensor may become damaged.
d. Do NOT use the reathalyzer D ingo A-025 as a tool to drink and drive.
e. Keep out of extreme temperatures and out of the reach of children.
f. To maintain accuracy, professional recalibration of t e reathalyzer
D ingo A-025 must be performed every 200 tests or at least once yearly
(12 mont s), w ic ever comes first. To recalibrate, you must mail your
device to the address at the end of this manual. Please contact us for
details and related fees.

6. Specifications for Breat alyzer Dingo A-025.
Method of Measure reath sample to AC
Range 0.00% to 0.40%
Accuracy +/-0.01% up to 0.10% AC
Sensor Oxide semiconductor
Power Two 1.5V AA alkaline batteries (included)
Testing Capacity Approx. 200 with new batteries
DOT Approved YES
Operating Temperature 10 – 40 degrees Celsius
Warm Up Less than 1 minute
Display 3-digit LED
Size (mm) 104 mm x 40 mm x 20 mm
Weight 85 g
Recalibration Recommended every 200 tests or at least once yearly,
whichever comes first
7. Warranty. The manufacturer warrants the product to be free from defects in
workmanship or material (excluding calibration) under normal use for one (1) year
from the date of purchase. The manufacturer’s obligation under this warranty is
limited to replacing, adjusting or repairing the unit if returned along with proof of
purchase. This warranty is void if the unit has been tampered with or maliciously
damaged. Recalibration is a periodic maintenance procedure required of any and
all breathalyzers in order to maintain accuracy, and as such, is not a warranty
service.
8. Recalibration. For recalibration or technical support, please contact us using the
information below.
http://www.kupi-alkotester.ru