Direct Color Systems DJ1024UVMVP Manual

LCD Control Panel
Test Printer Functionality
Turn on print engine by pressing . Amber
light will turn off. When green light is solid,
print engine is powered on and ready.
With print engine at ma height, test basic
functions of printer movement
Press and hold to move media table all
the way to the right. Media table will stop
once it has reached the right limit of printer.
Press and hold to move media table all
the way to the left. Media table will stop
once it has reached the left limit of printer.
Press to bring the media table to the
Print Home position. Media table will travel
to the right limit and advance several inches
to the left, and lock in the print home
position deactivating the and buttons.
Press to unlock the media table from
the print home position. Media table will
travel to the right limit of printer and
will be active again.
Test slow function by pressing and holding
to view the slow speed screen.
For further instructions, please refer to the
Getting Started Guide.
Read Me First
The full DJ1024UVMVP User's Guide has
been provided in digital format on the
orange USB security device (dongle).
The guide can also be found on our ftp site:
ftp://ftp.directcolorsystems.com/.
Login: dcs Password: dcsftp
99 Hammer Mill Road
Rocky Hill, CT 06067
[phone]
[e-mail]
www.directcolorsystems.com
Rev. 1.2
030314

Out of the bo
Remove the printer from its packing. Do not
dispose of the bo . The printer weighs 231
lbs (104kg) so at least two people are needed
to lift the printer. Place it on a flat, stable
surface with a minimum of 12" (305mm) of
space on all sides. Locate the table so that
you have access to all sides of the printer.
Ensure that all leveling feet are fully on the
surface of the table. The printer should be
determined to be level in all directions.
DO NOT PLUG IN THE PRINTER ET
Getting Familiar with the
1024UVMVP
Removing Shipping Brackets
DO NOT PLUG IN THE PRINTER ET
Warning: When printer is in operation, all covers
should be installed and closed with the front cover
lock screws installed and secured. The cover should
only be opened by trained DCS personnel only
Using the provided T15
Tor tool, remove the two
front cover lock screws.
Open the front cover using
both handles.
Remove the bolts securing print
engine to shipping brackets with
the provided T-handle tool. Do not
dispose of these bolts.
Remove the warning label over the AC power
receptacle. Plug in main power cord and flip
main power switch to ON.
The Ink Level screen will appear on the LCD
Touch Screen. Silence the alarm by hitting any of
the LOW ink lights.
Select the Home icon from the top left of the LCD
screen. Press and hold to raise the print
engine to its ma imum height.
Remove the tape from the
media table and shipping
brackets.
Remove the two brackets by
unscrewing them from the main
channel. ou cannot simply pull
these brackets out. Do not
dispose of these brackets.
Close and secure front cover.