Direct Wicker SICILY User manual

TABLE ASSEMBLY INSTRUCTIONS . DIRECT WICKER
TABLE
ASSEMBLY INSTRUCTIONS
BEFORE YOU START ASSEMBLING YOUR
FURNITURE:
CHECK THAT YOU HAVE ALL THE
PIECES LISTED ON THE LEFT HAND
SIDE.
LAY A CLEAN SHEET ON A FLAT
SURFACE BIG ENOUGH TO ASSEMBLE
YOUR FURNITURE ON IN ORDER TO
PROTECT YOUR FURNITURE.
A
1
B
1
C
1
D
1
E
11
F
1
G
1
1.
Lay the table top (A) down so the frame is facing upwards. With the slit facing
upwards, attach chair legs (B), to the table top by aligning the screw holes
with those in the table top (A) . Insert screws (E) through the washer andinto
theholesandlooselytightenwiththeallenkey(F).
Theninserttableleg(C)intopositionovertheslitoftableleg(B)andalignthe
screwholeswiththeholesinthetabletop(A).Insertscrews(E)throughthe
washerandintotheholesandlooselytightenwiththeallenkey(F)inthe
locationsshownin theimagebelow.
2.
Attach both the table legs together by placing the bracket (G) over the screw
holes on the bottom of table leg (B & C) as shown in the above imageand
inserting the three remaining screws (E) through the washers and into the
bracketandtablelegs.Fullytightenusingtheallenkey(F).
Fully tighten all of the screws in the table using the allenkey (F) then place the
screwcapsoverallofthescrews.

TABLE ASSEMBLY INSTRUCTIONS . DIRECT WICKER
3.
Turnthetableuprightandplacethetemperedglass(D)
overthetabletop.