Discovery Telecom ART PROJECTOR User manual

CONTENTS
Neck
Base
Lens
10 Clear Drawing Discs
6 Color Markers
Poster
ASSEMBLY
BATTERY INSTALLATION
Thank you for your purchase of the Discovery Art Projector ! Through
the projector and use multiple discs for layering artwork to achieve a
variety of designs from the projector. Be sure to use this product in a
safe, traffic free environment. Please read all instructions and warnings
on this sheet prior to use. Keep this instruction sheet as it contains
important information for future reference.
6 COLOR MARKERS
1 POSTER
10 CLEAR
DRAWING DISCS
LENS
NECK
BASE
Use a Phillips head screwdriver to
remove the bottom battery cover.
Insert 4 AA alkaline batteries in the
polarity direction shown.
Replace the battery cover and tighten.
NOTE: Optional AC power adapter (not included) may also be used instead of batteries.
The manufacturer recommends using only a certified OUTPUT DC 6V, 150mA AC Adapter.
Press the neck down into the slot on
the back of the base.
NOTE: Adult assembly required.
Slide the back of the lens onto the
top of the neck.
NOTE: Please make sure the side that
says "Face Down" is on the bottom
before attaching to the neck.
Your assembled projector should
look like this.
NOTE: Do not disassemble.
1 2 3
1 2 3
™
ART PROJECTOR
PROJECTS ON WALLS AND CEILINGS
AGES 6+

BATTERY WARNING:
• Do not mix old and new batteries. • Do not mix alkaline, standard
(carbon-zinc), or rechargeable batteries. • Insert batteries using the correct
polarity. • Do not short-circuit the battery supply terminals. • Remove
batteries before storing. • Recycle or dispose of batteries according to
federal, state, and local laws. • Do not dispose of batteries in fire, batteries
may explode or leak. • Always use, replace, and recharge (if applicable)
batteries under adult supervision. • Do not attempt to charge
non-rechargeable batteries. • Rechargeable batteries are to be removed
from the toy before being charged. • Rechargeable batteries are only to be
charged under adult supervision. • Exhausted batteries are to be removed
from the toy. • Alkaline batteries are recommended. Use only the specified
voltage. • Keep these instructions for future reference.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, Including Interference that may
cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio TV technician for help.
Use the markers to draw or trace on the
discs.
NOTE: Only use the provided markers.
You can also create giant signs using the
discs. Store your markers in the holes on
the top of the base.
HAPPY
BIRTHDAY
MOM!
DRAW
After the disc has dried, place it on the top
of the base and tuck the edge under the
disc holder (A).
NOTE: DO NOT draw on the top of the
base. When placing disc on projector, flip
the disc over so the marker side is facing
down.
Place the projector on the floor or a table.
Turn the switch (B) on the back side ON
to project onto the ceiling.
Turn the projector on its side to project
onto the wall. Use multiple discs for
layering artwork to achieve a variety of
designs. Try playing games like
Tic-Tac-Toe!
NOTE: Use a damp cloth to wipe the discs
off. Allow to dry completely before reuse.
A
B
HAPPY
BIRTHDAY
MOM!
PROJECT
Conforms to ASTM D4236.
• If the appliance stops working, return it to the retailer or seek help
from an authorized service center. Do not repair by yourself.
• Remove the batteries when the product is not in use for a long
period of time.
• Put the product into its package when not in use and store neatly in a
dry, cool location protected from direct sunlight.
• Wash hand after use.
MAINTENANCE AND STORAGE
1 2
3 4 5
WARNING:
CHOKING HAZARD - Small Parts.
Not for Children under 3 years.
™
Distributed by and © 2020 ThreeSixty Sourcing Ltd. All rights reserved.
For US only: Distributed by and © 2020 MerchSource, LLC. Irvine, CA,
92618. All rights reserved. Tel: [phone].
© 2020 Discovery or its subsidiaries and affiliates. Discovery and
related logos are trademarks of Discovery or its subsidiaries and
affiliates, used under license. All rights reserved.
Printed in China
KEEP THIS INSTRUCTION MANUAL AS IT CONTAINS IMPORTANT
INFORMATION FOR FUTURE REFERENCE.
Due to continuous product improvements, the pictures on this
manual may differ slightly from the actual product.
SAFETY WARNINGS: PLEASE READ
BEFORE USE
• For Age 6 and up. Adult supervision required.
• Never aim or shoot the balls at other people.
• Adult supervision required.
• Do not stare directly at the light for any extended period of
time.
• Inspect the unit before each use. If it appears cracked or
broken in any way, disregard immediately.
• Transformer used with the toy are to be regularly examined
for damage to the cord, plug, enclosure andother parts, and
that, in the event of such damage, the toys must not be used
with this transformer until the damage has been repaired.
• The toy shall only be used with a transformer for toys.
• The transformer is not a toy.
• The toy only using output DC 6V, 150mA AC transformer.
• The toy to be disconnected from the transformer before
cleaning.
• The toy is not to be connected to more than the
recommended number of power supplies.
• This toy is only to be connected to equipment bearing either
of the following symbols: or
• Not suitable for children under 3 years misuse of transformer
can cause electrical shock.