Displaysense DTS650 User manual

1
Phone: [phone]
Email: [email protected]
Website: www.displaysense.co.uk
Instruction Sheet
DTS650 - Silver Corner Glass Display Cabinet - 650mm
Contents:
A 20 x Self Supports
B 5 x Adjustable Feet
C 1 x Assembled Back Panel
D 2 x Large Back Cross Bars
E 1 x Glass Back Panel
F 1 x Aluminium Upright
G 2 x Cross Bars
H 2 x Cross Bars
I 2 x Glass Side Panels
J 1 x Assembled Front
K 1 x Glass Door
L 2 x Door Hinges
M 2 x Hinge Plugs
N 1 x Door Lock
O 1 x Top Panel
P 1 x Bottom Panel
Q 4 x Glass Shelves
R 1 x Rubber Seal
Bottle of Display Cleaner and Allen Key supplied
Suggested Tools: Philips Screwdriver

2
1. Insert all shelf supports (A) into each upright using the markers for guidance by twisting in to
position, then attach the adjustable feet (B) into the bottom of each upright
2. Place the back panel (C) onto a flat, soft surface and slide the two large cross bars (D) into the top
and bottom corners of the panel, securing in place with the Allen key, then slide the glass back
panel (E) in between the two cross bars (D)
3. Finish the back by sliding the single upright (F) onto the glass panel and cross bars (D) and secure
with the Allen key
4. Next, attach the cross bars labelled G to the top and bottom of the back panel on the left side and
slide the glass side panel (I) into place
5. Repeat the same for the cross bars labelled H, sliding onto the
right hand back panel then slide the second glass panel into place
6. Attach the assembled front panel (J) by sliding into place
Hint: If you struggle to get the cross bars to freely slide into the
front panel gradually loosen the grub screws on the cross bars and re-tighten once the panel is
fitted
Please note: We advise that there are three people there to assist, with two people holding each
side panel in place for stability while the third person positions the front panel and attaches to the
cross bars
7. Once all components are screwed tightly in place,
gently lift the cabinet onto its feet
8. Attach the hinges (L) to the glass door (K) by screwing
into place onto the top and bottom of the glass,
ensuring that each hinge is 8 - 10mm in from the inside edge of the glass
9. Insert the hinge plugs (M) into the top and bottom holes on the front bars
10. Lift the glass door into the cabinet, aligning top and bottom hinges with the
corresponding hinge plugs

3
11. Screw the lock (N) into position using a Philips screwdriver
12. Finish the cabinet by inserting the top and bottom panels (O + P) and place the shelves (Q) onto the
supports
13. Finally, add stability to the glass panels by inserting the rubber seal (R) into the channels where the
glass meets the aluminium
Hint: Use the display cleaner as a lubricant to help ease the rubber seal into each channel