DMP Electronics PLB170S-SW User manual

English
Installation Instruction
UNPACKING INSTRUCTIONS
! Carefully open the carton, remove contents and lay out on cardboard or other
protective surface to avoid damage.
! Check package contents against the Supplied Parts List in the next page to assure
that all components were received undamaged. Do not use damaged or defective
parts.
! Carefully read all instructions before attempting installation.
IMPORTANT SAFETY INFORMATION
Install and operate this device with care. Please read this instruction before
beginning the installation, and carefully follow all instructions contained herein. Use
proper safety equipment during installation.
Please call a qualified installation contractor for help if you:
! If you don't understand these directions or have any doubts about the safety of the
installation.
! If you are uncertain about the nature of your wall, consult a qualified installation
contractor.
Do not use this product for any purpose or in any configuration not explicitly specified
in this instruction. We hereby disclaims any and all liability for injury or damage
arising from incorrect assembly, incorrect mounting, or incorrect use of this product.
1
Suit for:
VESA 100x100
VESA 200x100
VESA 200x200

Supplied Par ts List
2
(4)M4x12 Bolt-d (4)M4x30 Bolt-e
(2)Wall Plate Cover-c(1)Wall Plate with Arm-a (1)VESA 200 Plate-b
(4)M6x20 Bolt-f (4)M6x35 Bolt-g
(4)M8x20 Bolt-h (4)M8x35 Bolt-i
(3)Cushioned Nut-o
(4)M4 Washer-j (4)M6 Washer-k
(4)M4 Spacer-m
(3)M8x90 Lag Bolt-q (3)M10x80 Concrete
Anchor-r
(8)M6/M8 Spacer-n
(1)M6 Wrench-s(3)Plastic Washer-p
(7)M8 Washer-l
Tools Required 4mm Drill Bit
Phillips Screwdriver
10mm Masonry Bit
Carpenter's Level

Brick or Concrete Wall
Step 1 Mounting the Wall Plate to the Wall
3
90mm
4mm
a
ql
Wood Studs Wall
a
l
q
r
80mm
90mm
10mm
CAUTION!
WARNING
!This TV mount must be securely attached to the
vertical wall. If the mount is not properly
installed it may fall, resulting in possible injury
and/or damage.

4
Step 2
Step 3 Mounting the TV to the Wall Plate
3.1 3.2
3.3 3.4
1
2
Install VESA Plate to the back of TV
d to i j,k,l
m,n(if necessary)
First of all, make sure the diameter and length of the Bolt(d,e,f,g,h,i) your
TV requires. Once you have determined the correct diameter and length,
you will thread the Bolt into the TV using the correct Washer(j,k,l). Use the
Spacer(m,n) only if the bolts are too longer.
o
p
o
ps
VESA 100x100
VESA 200x100
VESA 200x200

5
Step 4 Final Installation
4.1 4.2
4.3 4.4
Install the Wall Plate Covers Adjust the Tilt Angle
Manage the Wires Level Adjustment
Thanks for choosing our products, enjoy the using.
c
s
s