Place the 80cm profile in the center of the
30cm profile like shown in the picture.
Connect the profiles with the 90° steel
connectors. Align it exactly square and tighten
the screws
Insert both of the M5 spring loaded slot nuts
into the slot or slide them in from one end.
Their distance should be approximately like
the distance of the holes in the tripod clamp.
Attach the Andoer DM-55 tripod clamp (e.g.
from Amazon) with the M5 countersink
screws. The height of the camera can be
adjusted by loosening these screws for one
rotation. For fine adjustment use the tripod
clamp. If you don’t like the feel of moving the
tripod clamp with the spring loaded nuts you
can rip the spring of one or both nuts easily
using a pair of pliers.
