Dometic 3109563.130B User manual

1
INSTALLATION INSTRUCTIONS
FOR BUILT-IN MOUNTING KIT
3109563.130B
FOR USE WITH
MODEL DMW13B
Kit No. Item Qty. Use With
3109563.130B Trim Frame (10) DMW13B
(Black)
A. ELECTRICAL REQUIREMENTS
* Observe all governing codes and ordinances.
* A 120 volt, 60 Hz. AC only, 15 or 20 amp fused elec-
trical supply is required (time delay fuse is recom-
mended)
* It is recommended that a separate circuit serving
only this appliance be provided.
The appliance must be disconnected from the
source of supply before attempting the installa-
tion of this Kit. The Kit is intended for use only
with above designated model.
B. GROUNDING INSTRUCTIONS
Improper use of this grounding plug can result
in a risk of electrical shock. DO NOT, under ANY
circumstances, remove the power supply cord
grounding prong.
For your personal safety, this appliance must be grounded.
In the event of an electrical short circuit, grounding reduces
the risk of electrical shock by providing an escape wire for
the electric current. This appliance is equipped with a polar-
ized 3-prong grounding plug.
It must be plugged into a correct polarized mating 3-prong
grounding type wall receptacle, properly installed and
grounded in accordance with the National Electrical Code
and Local Codes and Ordinances. Refer to Figure 1.
Figure 1
Form No. 3307617.005 6/01
(French 3307618.003)
©2001 The Dometic Corporation
LaGrange, IN 46761

2
If mating wall receptacle is not available or if you are not
sure if the wall receptacle is properly grounded and polar-
ized, have it checked by a qualified electrician. It is the
responsibility and obligation of the customer to have a prop-
erly grounded and correctly polarized 3-prong wall recep-
tacle installed by a qualified electrician. See Figure 1.
Consult a qualified electrician if the grounding instructions
are not completely understood or if doubt exists as to whether
the appliance is properly grounded. See Figure 2 for loca-
tion of electrical outlet inside the opening at the rear.
Figure 2
C. INSTALLATION PROCEDURE
CABINET OPENING
1. See Figure 3. All corners should be square. The floor of
the microwave must be level and capable of supporting
100 pounds.
2. Mount the trim frame on the outer case using three 12mm
screws supplied with microwave (two #8 screws not sup-
plied, can be added if desired). Then mount the duct on
the outer case using two 8mm screws (not supplied).
(See Figure 4)
3. Put the microwave oven into the cabinet.
4. Screw the upper and lower trim onto the cabinet using
four screws (not supplied). (See Figure 5)
Note: No screws supplied to install duct.
Figure 4
Figure 5
#8 Screw
(Optional)
#8 Screw
(Optional)
Lower Trim
Duct
These screws are removed from bottom
of microwave and used to secure frame to
microwave
These screws are removed from bottom
of microwave and used to secure frame to
microwave
MODEL DIMENSIONS
DMW13B 22.13” wide x 14.53” high
Figure 3
WxHxD
1. Set Size 21.97" 12.56" 16.77"
2. Opening Size 22.13" 14.53"
3. Cabinet Size 22.13" 14.53" 16.02"
(Dash Line)
WOOD CABINET
Min. 16.02
22.13
14.53
SHOULD BE SOLID BOTTOM