4. You can add holiday decorations to beautify this lamp post.
5. The lamp post is pre-strung and has powered tree pole. The adaptor has assembled
with wire connector. You can connect the adaptor to the wall outlet directly without
extra light connection. All lights should illuminate completing the assembly of your tree!
Enjoy your holiday!
Please note this tree is LYTE SYSTEMTM ("LightYourTree Easy" System)
ASSEMBLY INSTRUCTIONS
THIS LAMP POST IS FOR INDOOR USE ONLY!
Retain carton and instruction sheet for storage and further purposes.
Each carton contains two lamp post sections and one resin pot.
1. Choose a location where the lamp post is to be displayed.It should be on a levelsurface.
Make sure final assembly stable enough to hold the lamp post upright.
2. Take out the two lamp post sections and resin pot fromcartonand assemble.
Position the pot first,insert the bottom section pole into the pot base,
then insert the lamp post top into the bottom section pole as Figure 1 shown.
STORAGE
First unplug the power cord fromthe walloutlet.
Remove allholiday decorations,disassemble the two sections and secure themin place.
Alllamp post parts canbe replaced inits originalcartonand should be stored in a cooland
dry place.
WARNING FOR SAFETY USE
1. Never allow any part ofthe lamp post to contact a source ofheat or flames.
2. Caution: Artificialgreeneries have small parts which may pose a choking hazard if
detached fromthe branches. Keep out ofreach of smallchildrenand pets.
3. Always position the light string cord or any extension cord so that they will not be a
hazard to the elderly,childrenand pets.
4. Always fully insert electricalplugs into a receptacle.
TROUBLE SHOOTING TIPS
Forpre-littrees, ifthe tree does notilluminate:
1. Please check to make sure that the power cord is plugged into the walloutlet.
2. Please check for loose,brokenor missing light bulbs and replace as needed.
3. This lamp post is powered pole, ifthe powered pole connection is loose,
please email us for solution.We can replace one set line connector.
SPARE PARTS
For pre-lit tree, spare bulbs are included.
Please check attached manual for replacement guide.
Ifextra parts are needed, please contact our customer service center.
Email:customerservice@winnersarts.comor Calltoll-free:1-844 946 8733
Electrical Rating For the Lamp Post
Input: 120V-60Hz, 0.08A
Output: 28V-0.107A
(For Indoor Use Only)
3. Shape your lamp post's greeneries as Figure 2.Working your way up from the
bottom.The lamp post is easy to set up in a short time.
Figure 1
Figure 2
