DOREMIDI UTD-10 User manual

1. Introduction
The USB to DMX cable (UTD-10) is a high-quality light control converter designed by DOREMiDi.
UTD-10 has DMX and RDM functions, which can convert DMX/RDM to USB and connect to a
computer. UTD-10 has a communication indicator, which is convenient for operation and
debugging. In addition, UTD-10 has a built-in high-speed isolator that can isolate and protect
computers and external light control equipment, and an external magnetic ring shield can improve
anti-interference ability.
2. Appearance
❶XLR plug, connect RDM/DMX equipment.
❷USB connector, connect to Windwos, Mac, Linux and other equipment.
❸USB indicator light, after the USB connection, the indicator light is always on.
❹IN indicator, RDM input indicator, flashes after receiving data from RDM equipment.
❺OUT indicator, DMX output indicator, flashes after sending DMX data output.
3. Product Parameters
Name
Description
Model
UTD-10
Length
2 meters
Weight
100g
USB Plug
USB2.0 standard full-speed USB-MIDI plug
XLR plug
Standard three-pin XLR plug
Indicator Ligh
USB work indicator, RDM input/DMX output indicator
Compatible System
Windows, Mac, Linux, etc.
4. Steps for usage
1. Connection: Connect the USB-A plug of UTD-10 to the PC, and the XLR plug to the RDM/DMX
device.
2. Install the driver: Generally, Win8/Win10 will automatically discover the USB-DMX device. If it
is not found, you need to install the driver manually.
Driver download lin: https://ftdichip.com/drivers/vcp-drivers/

Select the driver to download according to the system situation, as shown in the figure for part
of the driver:
3. Software settings: Take FreeStyle X2 as an example
Install FreeStyle X2 software:
FreeStyle software download link: www.freestylerdmx.be
Set FreeStyle to connect to UTD-10:
Open "Setup→FreeStyle Setup", select "JMS USB2DMX" and "FT232R USB UART", and
then select "Save" to save the settings.

Add/remove DMX/RDM equipment:
Open "Setup→Add/Remove fixtures" and add/remove RDM/DMX devices according to
the picture.
5. Precautions
1. This product contains a circuit board
2. Rain or immersion in water may cause the product to malfunction
3. Do not heat, press, or damage internal components
4. Non-professional maintenance personnel are not allowed to disassemble the product
5. The working voltage of the product is 5VDC, using a voltage lower or exceeding this voltage
may cause the product to fail to work or be damaged

6. Q&A
Question: Recognized after connecting to a computer.
Answer: Please make sure that the computer has been correctly installed the driver, the driver link:
https://ftdichip.com/drivers/vcp-drivers/
Question: After connecting to the DMX lamp, the lamp cannot be controlled normally.
Answer: Please make sure that the DMX channel that occurs is consistent with the lamp.
Question: After opening the software, the interface fails to open, or the software does not
recognize the UTD-10 cable.
Answer: Re-plug the UTD-10 cable, or use another USB interface, or restart the application
software.
If the problem is not resolved, please contact customer service.
Manufacturer: China Show (Shenzhen) Technology Co., Ltd.
Address: Room 9A, 9th Floor, Kechuang Building, Quanzhi Science and Technology Innovation Park,
Shajing Street, Baoan District, Shenzhen, Guangdong Province
Customer Service Email: [e-mail]