DORMEO OFD-CON555-BLK User manual

Model Number: OFD-CON555-BLK / OFD-CON555-GRY
Contour Executive Chair
1. To Adjust Seat Height:
While seated, lean forward and reach under the right
side of the chair to find the handle. Lift the handle
and raise your body up slightly to allow the chair to
rise to the desired height. To lower the seat, lift the
handle while applying more weight downward on the
seat. The chair will descend until the handle is
released or the chair reaches the bottom position.
2. To Operate Tilt Lockout:
Reach under the left side of the chair to find the
handle. Flip the handle down and lean back to allow
the chair to tilt backwards. Flip the handle up to lock
the chair angle while the desired position is reached.
3. To Adjust Tension on the Tilt
Mechanism:
Reach under the front center of the chair, grasp the
round knob and turn counter- clockwise to make the
tilt mechanism firmer (stiffer). To make the tilt
mechanism less firm, turn the knob clockwise until
the desired resistance is found.
4. 360°Swivel:
360°seat swivel.
OPERATING INSTRUCTIONS

Model Number: OFD-CON555-BLK / OFD-CON555-GRY
Contour Executive Chair
A. Remove all parts from carton and separate them into part number groups as indicated in the parts list.
B. To begin assembly, place 5 Star Base (2) upside down and insert Casters (1) into bottom of Base (2).
C. Turn Base (2) right side up on the floor and insert Gas Lift (3) into center hole on Base (2).
D. Align the Back Cushion (7) with the Seat Cushion (5) and attach the Back Support Plate (8) onto the bottom of the
Seat Cushion (5) by using 1-1/4” Screws (9) as shown in Diagram 1. Do not tighten screws completely.
E. Attach Seat Plate (4) onto the bottom of Seat Cushion (5) (with front of seat plate facing front of seat cushion) by
using 1-1/2”Screws (10) for front holes of Seat Plate (4) and 1”Screws (11) for rear holes of Seat Plate (4) as
shown in Diagram 2 and tighten screws.
F. Insert 2" Screws with Spring Washers (12) into arm holes attaching Arms (6) (with front of arms facing the front of
seat cushion) to sides of Seat Cushion (5) and Back Cushion (7). Now, tighten all the screws. Remember to
tighten the back support plate screws also!
G. Place the assembled chair on top of Gas Lift (3) and press down until fully engaged.
H. Place the Plastic Caps (13) into arm holes once screws have been tightened.
I. Periodically (every 90 days) tighten all screws in the chair.
ATTENTION: Make certain all screws are fully tightened before using chair.
Part #
Description
Quantity
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
Casters
5 Star Base
Gas Lift
Seat Plate
Seat Cushion
Arms
Back Cushion
Back Support Plate (already
attached to the back cushion)
1-1/4”Screws
1-1/2”Screws
1”Screws
2”Screws with Spring Washers
Plastic Caps
Allen Key
5
1
1
1
1
2
1
1
4
2
2
4
4
1
A S S E M B L Y I N S T R U C T I O N S
P A R T S L I S T