Douglas UNICOURT 68300B User manual

10'1”
10'1”
1'2"
61 1/4"
PART A
PART B
PART C
20 1/2"
1
2
3
10-8
15-8
25-8
61 1/4"
Pole Cap
Fig 1
Fig 2
Fig 1
Refer to top
left, and next
page for ground
sleeve installation.
4
12-8
Brace Fitting
A
A
A
A
B
B
B
B
B
B
B
B
B
B
C
C
C
1
3
3
1
2
2
4
4
Side View
Side View
1 0’ x 20’ Rebounder Assembly
Item # 68300B
4
4
D
D

1 0’ x 20’ Rebounder Assembly
Item # 68300B
PARTS LIST
Reference Qty Description
A (4) 61-1/4” Tube
B (10) 61-1/4” Tube with swag
C (3) 20-1/2” Tube
D (2) 12“ Braces
Reference Qty Description
1 (2) 10-8 Kee Klamp
2 (2) 15-8 Kee Klamp
3 (2) 25-8 Kee Klamp
4 (2) 12-8 Brace Fitting
Fig. 1 Fig. 2
3'
2'
2'
3'
2'
2'
1’6”
1. Sink PVC sleeves to a depth of 2’ in concrete that is at least 3’ deep; as shown on
the illustration. Note that the center pole is set back from the (2) end poles.
2. Assemble bottom bar over the holes as a guide. Lift off, lay down and finish
assembly of frame on the ground. Use the set screw key to secure poles in fittings.
Be sure the whole frame, including the 1’ set backs, are assembled before
installing the net.
3. To install netting hook and fasten bungee cords evenly along sides and top of the
frame. Evenly space and tighten down the 20 adjustable straps along the bottom
of the netting.
4. Attach vinyl skirt at bottom using ty-raps. Thread white webbing into netting at
desired location to simulate net height.
Qty Description
(1) Vinyl Skirt
(10) Release Ty-raps
(1) Webbing Strap
(1) Set Screw Key
Qty Description
(3) 2” i.d. PVC ground sleeves
(1) Pole Cap
(1) Rebound Net
(30) Bungee Cords
(20) Adjustable Straps