Down East Brittany User manual

size:40*40*185mm size:M8*30mm
Middle leg (G) 2pcs Inner hexagon screw (a) 8 pcs
Cup nut (e) 8 pcs Plastic washer (f) 2 pcs
Brittany Bed Assembly Instruction
Headboard (A) 1 pc
Wing (B) 2 pcs
Footboard (C) 1 pc
Side rail (D) 2 pcs
Slat (E) 1 set
Middle leg rail (F) 1pc
size:M8*70mm
size:Ø 22mm
size:Ø 8mm
Threaded bolt (b) 8 pcs
Flat washer (c) 6 pcs
Bent washer (d) 6 pcs
Ø:5mm
Ø:14mm
Allen wrench (g) 1 pc
Wrench (h) 1 pc
Step 1. Put the Headboard (A) upon to the L shape legs of Wing (B) and install the Wings, tighten the Inner hexagon screws (a), and veil the dust cover.
Step 2. Screw in the Threaded bolt (b) to the Wing (B) and Footboard (C), and tighten the Threaded bolts by hand.

Step 3. Install the Side rail (D) into the Wing (B) and Footboard (C) as picture shown, make sure the little blocks is facing upwards. Tighten the Cup nut (e),
Bent washer (d) and Flat washer (c) with Wrench (h).
Step 4. Install the Middle leg (G) with Plastic washer (f) into Middle leg rail (F), and plug into the brackets in Headboard and Footboard. There is an adjuster
under the Middle leg, you may need to adjust it a little bit to touch the floor.
Step 5. Put the Slat (E) on the rails, lock it as shown and make it parallel.
CAUTION: Do not attempt to move the bed when fully assembled. This could result in damage to the rails, headboard, or footboard.
little blocks
facing