Note: When the clothes dryer is operating on a spin cycle, the Dryer Stand Maxi may experience a small vibration. The Dryer Stand Maxi is stable and designed to
sustain such movements, so please do not be concerned if this occurs.
Caution: Ensure your clothes dryer with wet clothes does not exceed the maximum weight load of 100 kilograms.
CCross Bar Nut - Qty. 1
Atach the adjustable feet
to the two side frames
Slide the shelf into the top
rails of one of the frames.
Slide the second frame
into the shelf.
It might be easier to get
someone to help with this
part. Screw the handbolts
in, but do not tighten
them yet.
Note: You might nd it
easier to install the bottom
rail after this this step.
Fasten the two scross
braces to each other using
the centre hole and 15mm
M8 bolt and nut.
Attach the crossbrace to
the back of the frame.
Once the stand is fully
assembled, Tighten the
Crossbrace and then the
handbolts.
Do one nal check to make
sure all of the nuts and bolts
are rmly tightened with
allen key.
Screw in the adjustable rails
to the side frames.
It is important that you make
sure you use the bottom rail
for the bottom of the side
frame.
Use the M8x45mm bolts to
tighten the tails.
A
DM8x45 Bolt - 6
Adjustable Foot - 4
Disconnect and remove your
washing machine. Place the Dryer
Stand Maxi in its space.
Move the washing machine in
between the stand and reconnect
the power cord and hoses.
Place your dryer on top of the
stand.
BM8x15 Bolt - 5
Choose from 6 dierent
widths. The lower the
attachment are wider the
stand will be.
Please ensure both sides
match when installing
the cross brace.
EHand Bolt - 6
