2"
"
5-#67-#$&D03(-/3>&8E-#67-#$&70//&:$&<"()6&")&()6$#306$&"<&,E$&306$&6$3F&8@==&
&
+,$9&B:""Carefully"lower"center"section"8?="so"that"it"is"flat"on"its"back."
+,$9&C>&&Install"G$%$/$#3&(5)"in"the"bottom"of"the"center"section"(?)."After"installing"the"G$%$/$#3"and"
setting"the"center"section"(?)"upright,"it"may"be"necessary"to"adjust&G$%$/$#3"to"ensure"proper"door"
alignment.""
+,$9&H>&Attached"to"the"underside"of"the"desk"(@)"will"be"the"legs"(@AB"and"@AC)"and"any"needed"
hardware.""Place"leg"(@AB)"so"that"the"screw"holes"are"facing"inward"towards"the"corner"bracket."Refer"to"
!0*(#$&?"
"
"
"
"
&
+,$9&I>&&Insert"threaded"stud"on"leg"through"corner"bracket."Then"place"a"J-3E$#"followed"by"a"G"4F&
J-3E$#&followed"by"a"K(,"on"the"threaded"stud"outside"the"corner"bracket.""Ensure"leg"is"secure"by"
tightening"the"K(,"with"½”"socket"or"wrench,"but"be"careful"to"not"overtighten"as"this"could"pull"stud"
from"leg"
Repeat"+,$93&H"and"I"to"attach"the"second"leg"(@AC)"""
+,$9&L>&Slide"!$##(/$3"over"legs"and"screw"in"G$%$/$#3&