Dundalk LeisureCraft Signature User manual

Ph: 519-923-9813 | Fax: [phone] | Web: www.dundalkleisurecraft.com
Assemble porch benches (if applicable) by
fastening seat assemblies to front assemblies
usig oe ½” Kreg Screw per joint (2 joints)
Seure to the frot wall of saua with 4  ½”
screws into the pre drilled holes as in picture.
Fasten through the outer wall into the back of
the eh seat frae with  ½” srews  plae.
Screw the outer leg of the assembly to the floor
usig a  ½” Kreg screw in the pre drilled hole.
The sauna interior benches have a support at
each end and supports in the middle of benches.
Dundalk LeisureCraft
Signature Sauna Bench
Assembly Instructions
Place front assembly on top of flat floor and level
the bench.

Ph: 519-923-9813 | Fax: [phone] | Web: www.dundalkleisurecraft.com
Join the bench supports at the top of the bench
front by their square ends with two kreg screws.
Level the Bench Support, and join the angled
end to the sauna wall with two Kreg screws, as
shown.
Place the bench seat on top of the installed front
assembly as shown.
Secure the top of the bench to the bottom
assely i the frot with two ½” dek srews
(2 places, as shown below)
Dundalk LeisureCraft
Signature Sauna Bench
Assembly Instructions
Before fastening top bench to front assembly,
Srew eh raket to eh support usig ”
screws.