Dunlin Campaign Safari User manual

!
A. Two Rear Legs. Identifiable by small drill hole in top block of each leg.
B. Four support bars.
C. Two Sling Braces.
D. Two Front Legs.
E. Two cotton ropes. Long for Wide Sling. Short for Narrow Sling.
F. Narrow Sling.
G. Wide Sling.
H. Two Hex Head Bolt
I. Two Arm Straps
J. Rear Sling
K.Two Nuts
L. Four sets of washer, screws and caps.
A
C
G
A
F
B
D
E
H
I
J
L

Turn Front Legs and Rear Legs upside
down on asoft rug or carpet.
Insert the four support bars into the drilled
holes on the Front and Rear Legs
Rear
Front
Rotate assembled chair frame so its
standing.
Loop the narrow sling between the left and
right support bars. Weave the rope through
the grommets as tightly as possible and tie
off.
Loop the wide sling between the front and
rear support bars and over the top of the
narrow sling. Weave the rope through the
grommets as tightly as possible and tie off.
Rear
Front
Rear
Front
A
A
D
D

!
Insert the two sling braces, C, into the back
sling, aligning the drill holes in the sling
braces with the opening in the back sling.
Push the hex head bolt into the Rear Leg
until it is recessed, asmall rubber hammer
may help here.
Slide the sling brace over the bolt and
secure in place with the supplied nut.
Rotating the chair 90 degrees on the rug
may assist in fixing the nut to the bolt. Also
ensure the bolt has been recessed into the
Rear Leg
J. Sling
shown with
cutout
Rear Leg A
K. Nut
Ensure H. Hex
Head
Bolt is recessed
into Rear Legs.

Take one of the Arm Straps and position the
one end of the straps metal eyelet over the
recessed thread in the Front or Rear Leg.
Insert the screw through the washer and
then insert the screw through the Arm Strap
metal eyelet.
Screw into place securing the Arm Strap in
place.
Finish by placing the chrome cap over the
screw head.
Repeat for the other three connections.
I. Arm Strap
A. Rear Leg
L. Screw
L. Washer
L. Chrome Cap