DutchCrafters GCT0060D Firmware update

#GCT0060D, #GCT0060C, #GCT0060B
HARDWARE PACKAGE
8 ¼" x 2" Allen Head Bolts
8 ¼" Flange Nuts
2 Umbrella Knobs
16 3" Screws
12 1½" Screws
8¾" Screws
1Allen Wrench
PACKAGE CONTENTS
1Top
2 Bases
1 Cross Support
1 Center Leg
2Footrests (Bar and Counter Height Only)
4 Braces
1 Hardware Package
TOOLS NEEDED:
Hammer
7/" Wrench
Cordless Drill/Screwdriver
Allen Wrench (Included)
Firmly tap bolts into pre-drilled
holes before tightening.
CORRECT INCORRECT
1 2 34 5
Use to measure bolts
Umbrella
Holder
Cross Support
Base
Upright
Top Boards
Apron
Footrest
NOTE: Bar and
Counter Height Only
Assembly Directions for
60" Round Table

STEP #1 - First, assemble the cross support to the base
using 3" screws. Second, fasten the footrests
to the base using 3" screws (Bar and Counter
Height Only.)
STEP #2 - With the second base, repeat step #1.
STEP #3 - Position the center leg over the umbrella plug
and fasten the center leg to the top using
¾" screws. Caution! To keep screws from
spinning out, do not overtighten screws!
STEP #4 - Lift the base assembly onto the top. Fasten the
base assembly to the aluminum frame using
¼" x 2" Allen Head bolts.
STEP #5 - Fasten the braces using 1½" screws and then set
the table upright.
Your 60" Round Table is complete!
3" Screws
Footrest
Cross Support
Base
Base
3" Screws
Center Leg
¾" Screws
¼" x 2" Allen Head Bolts
1½" Screws