DW DWC-PV20HMW User manual

Hanging mount for multi-sensor vari-focal cameras
Quick Start Guide
Tel: [phone]
Technical Support Hours: 9:00AM – 8:00PM EST, Monday through Friday
digital-watchdog.com
NOTE: Download all your support materials and tools in one place.
1. Go to: http://www.digital-watchdog.com/resources
2. Search your product by entering the part number in the ‘Search by Product’ search bar. Results
for applicable part numbers will populate automatically based on the part number you enter.
3. Click ‘Search’. All supported materials, including manuals
and quick start guide (QSGs) will appear in the results.
DWC-PV20HMW
WHAT’S IN THE BOX
Camera Mounting Screws 2Quick Setup Guide 1
Safety Wire 4Hexagonal Wrench 1
Hanging mount for multi-sensor vari-focal camerasHanging mount for multi-sensor vari-focal cameras

Quick Start Guide
Rev: 01/23
Copyright © Digital Watchdog. All rights reserved.
Specifications and pricing are subject to change without notice.
INSTALLATION
1Secure the hanging mount to the pole (NTP ¾ thread).
2Before attaching the camera to the hanging mount, remove the dome from the
camera base.
3Ax the safety wire at the bottom of the hanging mount. Connect the other
side of the safety wire to the base of the camera.
4
To mount the camera to the mounting accessory, remove the dome from the
camera base using the wrench included
with the camera.
5Pass wires through and make all necessary connections.
6Use the camera mounting screws (included with bracket) to secure the camera
to the mount cap. Align the indented lines on the side of the camera with the
lines on the hanging mount. Rotate the camera clockwise to lock into position.
UNLOCK LOCK
7Adjust the camera lens module’s position and secure the dome cover to the
camera. See the camera’s QSG for camera setup information.
NOTE: Do not touch the lenses when handling the camera modules.
Pipe
Mount Cap
NTP 3/4 TAP