DXV Equility D35109430 User manual

INSTALLATION INSTRUCTIONS
SAVE FOR FUTURE USE
RECOMMENDED TOOLS AND MATERIALS
Most of the procedures require the use of common tools and materials, which are available from hardware and plumbing
supply stores. It is essential that the tools and materials be on hand before work is begun.
- 1 -
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2017 M965671 Rev. 1.3 (5/18)
Model D35109430
To be used with
D35000420.191 - 3/2 Two Way In-Wall Diverter
D35000430.191 - 4/3 Three Way In-Wall Diverter
Equility™ (Formerly LYNDON®)
Handle Trim Kit for
2-Way or 3-Way In-Wall Diverter
ROUGHING-IN DIMENSIONS:
• For reference
Plumbers' Putty or Caulking
Phillips Screwdriver
Flat Blade Screwdriver
FINISHED
WALL
3-3/4"
(95 mm)
1-7/8"
(48 mm)
1-7/8"
(47.4 mm)
In the United States:
DXV
One Centennial Avenue
Piscataway, New Jersey 08855
Attention: Director of Customer Care
For residents of the United States, warranty
information may also be obtained by calling
the following toll free number: [phone]
www.DXV.com
In Canada:
DXV
5900 Avebury Road
Mississauga, Ontario
L5R 3M3
Canada
Toll Free: 1-800-387-0369
Local: 905-306-1093
Fax: [phone]
www.DXV.ca
In Mexico:
DXV
Via Morelos 330
Col. Santa Clara Coatitla
Ecatepec, Estado de México 55540
Toll Free: 01-800-8391200
www.DXV.mx
Thank you for selecting DXV. To ensure that your
installation proceeds smoothly, please read these
instructions carefully before you begin.

- 2 -
2
7
1
3
4
5
6
M964000-YYY0A
ESCUTCHEON
M964102-YYY0A
HANDLE KIT
M964961-1000A
EXTENSION KIT
H960835.XXX
HOLDER
H960873.191
ADAPTER
M964812-0070A
HANDLE RING
M965671 Rev. 1.3 (5/18)
Replace the “YYY” with
appropriate finish code
POLISHED CHROME 100
BRUSHED NICKEL 144
MATTE BLACK 243
MODEL NUMBER
D35109430
Equility™
(Formerly LYNDON®)
Handle Trim Kit for 2 -Way
or 3-Way In-Wall Diverter
1INSTALL HANDLE
CAUTION Turn off hot and cold water
supplies before beginning.
• Use the HEX KEY (1) provided to loosen the handle SET SCREW (2) and take out the HOLDER ASSEMBLY (3) from HANDLE (4).
• Install ESCUTCHEON (5) onto HOLDER ASSEMBLY (3) as shown and apply sealant to groove on back side of
ESCUTCHEON (5).
• Install HOLDER ASSEMBLY (3) with ESCUTCHEON (5) onto DIVERTER VALVE (6). Thread HOLDER ASSEMBLY (3)
onto rough valve until ESCUTCHEON (5) is ush against the wall.
• Install HANDLE (4) onto HOLDER ASSEMBLY (3) and secure by tightening
SET SCREW (2).
• Install PLUG BUTTON (7).
• Turn on the water supply. Check that the tting works
correctly and does not leak.