Dyna-Glo WBL100 Installation instructions

1
Installation of Support Legs
(Cannot be used for garage and ice-house applications)
NOTE: This accessory is required for safe operation when heater is
oor mounted.
Before installing Support Legs to heater base, please make sure
you have the following items:
If any part is missing or damaged, do not attempt to assemble the product.
Contact our Technical Service Department at 1-877-477-4768 for
replacement parts.
1. Set down a blanket onto the table where the heater will be placed for leg
installation to prevent scratching of the table and/or the heater.
2. Set back of heater on table with the bottom of heater extending outside
the table edge.
3. Fasten Support Legs to heater using Support Leg Screws.
Support Leg
Screw
Support Leg
DYNA-GLO
SUPPORT LEGS
WBL100
To be used with all Dyna-Glo
Wall-Heater Models
MODEL #
IMWHL - 2015-04-10
Support Leg Screw
(M4*15) x 4
Support Leg x 2

2
WARRANTY
If within one year from the date of original purchase, this item fails due to a defect in material or
workmanship, we will replace or repair at our option, free of charge. To order parts or to obtain war-
ranty service, call 1-877-447-4768, Monday - Friday, 8:30 a.m. - 4:30 p.m. CST. This warranty does
not cover defects resulting from improper or abnormal use, misuse, accident, or alteration. Failure to
follow all instructions in the owner’s manual will also void this warrranty. The manufacturer will not be
liable for incidental or consequential damages, or common erosion of outdoor products. Some states
do not allow the exclusion or limitation of incidental or consequential damages, so the above limita-
tion may not apply to you. This warranty gives you specic legal rights, and you may also have other
rights which vary from state to state.