Eastern Jungle Gym Dream or Fantasy Wood Roof Setup guide

This instruction booklet is to be used exclusively for Eastern Jungle Gym
customers only. It is not to be handed out to the general public. Any duplication of
this booklet will be subject to copyright protection and federal laws.
Owners & Instruction
Manual
Wood Roof ADD ~ ON
“Creating Childhood Memories”
R

Wood Identification
2 @ 2”x4”x64 ” (Roof Joist LEFT) Part # WR2464L
2 @ 2”x4”x64 ” (Roof Joist RIGHT) Part # WR2464R
2 @ 2”x4”x64 ” (Roof Joist TEAK) Part # WR2464T
26 @ 5.5”x3/4”x58 ” (Roof Board) Part # RB58
2 @ 5.5”x3/4”x58 ” (Top Roof Board) Part # RB58T
1 @ 3”x3/4”x58 ” (Roof Cap LEFT) Part # RC58L
1 @ 2 1/4”x3/4”x58 ” (Roof Cap RIGHT) Part # RC58R
2 @ 5½”x3/4”x10 ” (Gable Gem) Part # GG10
4 @ 3.5”x3.5”x8 ” (Wood Roof Block) Part # WR448
“Creating Childhood Memories”
R

Dream or Fantasy WOOD ROOF Assembly
Layout 2 - 64” 2x4 Roof Joists
ID# WR2464. With angle cut facing
the ground and away from you (as
is photo)
NOTE: Start roof board with joist
at bottom of groove edge. (as is
photo)
Place 1 - 1x6 Roof Board
ID# RB58 on top of roof joist (as is
photo) Letting roof boards
overhang 5” on each side. Install
with 1 - 1½” screws on each side.
Place second - 1x6 Roof Board
ID# RB58T on top of roof joist (as
is photo) Letting roof boards
overhang 5” on each side. Install
with 1 - 1½” screws on each side
as in the first board.
NOTE: this board is temporary,
to help hold joists in place while
assembly roof panel.
Measure from corner to corner to
square of box making sure
measurements are the same.
This will square off your wood
roof.
NOTE: Once square you can
install the other 4 - 2” screws into
boards that we left out earlier.
Now install your next 10 roof
boards RB58 with 4 - 1½” screws
in each board (as shown in photo)
Remove top temporary roof
board. Installed earlier. Place remaining 3 roof boards
installing with 4 - 1½” screws on
each board and placing roof
board RB58T as last roof board.
NOTE: Last roof board will extend
past the roof joist.
Angle Cut
WR 2464 5” 5”
Install only one
2” screw for now.

Turn roof panel over and install
64” 2x4 roof joist teak
ID# WRT2464. Laying flat on roof
boards in center and install with
1½” screws (as shown in photo)
Duplicate process for second wood
roof panel.
WOOF ROOF PANELS ARE
COMPLETE!!!
NOTE: Remember to hold last
roof joist flush with groove edge.

From outside of clubhouse place
10” gable gems ID# GG10 along
76” 4x4 tent support TS4476 into
peak of wood roof and install with
2 - 2” screws.
Assembly roof cap boards RC58L
together with 1½” screws. Place
roof cap on peak of roof and
install to wood roof with 2 - 1½”
screws on each side.
From inside of clubhouse fasten
upper end of roof with 1 - 3” lag
through roof joist into 76” 4x4 tent
support TS4476.
With walls, rails and tent supports installed, place 8” 4x4 wood roof
blocks WR448 on inside of each corner, where 96” 2x4 wall rail and
58” 2x4 rail meet (as shown in photo)
Install wood roof block WR448
along side of 96” 2x4 rail by
drilling a 7/8 counter sink hole and
installing 1 - 3” lag through rail into
block.
Place first wood roof panel on 58”
2x4 tent rail up to 55” 2x4 tent
support.
Place second wood roof panel on
opposite side of clubhouse. From underside of wood roof
panel. Install with 1 - 3” lag bolt in
each corner through roof joist into
roof blocks WR448.
Dream or Fantasy WOOD ROOF Installation