Eastern Jungle Gym 5' MONKEY BARS Setup guide

Owners & Instruction Manual

1

2

6
3
*Eastern Jungle Gym models with an A-frame design do
require a level area for installation.
Site Location
Our exclusive leveling system was developed through more then 26
years of installation experience. This unique leveling system ensures
safe installation on un-level properties*.
While your jungle gym will be level and safe some of the activities will be
affected by the sloping property (notice the Rock Wall vs. Ladder in Diagrams A1
and A2). For example if your slide is facing downhill (or uphill) it will be at a
steeper (or more shallow angle) than normal; therefore it will be faster (or
slower) (Diagrams B1 and B2). If your swing beam is installed downhill (or
uphill), the swing position closest to the end will be lower to (or further from
the ground) (Diagrams B1 and B2).
To determine play area size, it is recommended that you add six feet to the
jungle gym dimensions on all sides. However, besides swing beam side supports
and other low traffic areas it is not critical to have a six foot “play area”.
Installing a resilient surfacing under the jungle gym is always recommended, and
can be done AFTER your jungle gym is installed.
A1 A2
B1 B2
Level Yard
Level Level
Level Level
Rock
Wall Rock
Wall
Property Slope
Property Slope
Property
Slope
Property
Slope
Property Slope Ground Support Follows
Slope of Property

4

Accessories Identification
1-Roll of electrical tape
5

Hardware Identification
H6
H4
B5
B3
B2 S2
S1
N1 W3/8 W5/16
6
H6
H4
B5
B3
B2
S2
S1
N1
W3/8
W5/16-

7

Wood and Kit Identification 5’ Monkey Bars
2 @ MONKEY BAR UPRIGHTS PART #M4478
1 @ MONKEY BAR OVERHEAD RIGHT PART #M4478R
1 @ MONKEY BAR TIE LEFT PART #MT2412L
1 @ MONKEY BAR TIE RIGHT PART #MT2412R
8 @ MONKEY BAR RUNGS AND HARDWARE
1 @ MONKEY BAR OVERHEAD LEFT PART #M4478L
8

Step #2-Monkey Bar Overhead 5’ Monkey Bars
Step #1-
Monkey bar Upright 5’ Monkey Bars
Layout (2) M4478 Monkey bar
uprights and 3 15 1/8” monkey bar
rungs. Make sure angled cut sides are
facing in the same direction.
Measure from the bottom of the
uprights and make a mark as shown in
the drawing. Measurements are to
the center of the rungs. Install using
S1 screws. Repeat on opposite side.
Layout (1) M4478R and
(1)M4478L Monkey bar overhead
and 5 15 1/8” monkey bar rungs.
Make sure angled cut sides and
square sides are facing in the
same direction.
Measure from the bottom
of the uprights and make a
mark as shown in the
drawing. Measurements
are to the center of the
rungs. Install using S1
screws. Repeat on opposite
side.
Angled End
9
40X