Eastern Jungle Gym Classic tire Setup guide

Owners & Instruction Manual
2021

1
Customer Service available 9-5pm EST Mon-Fri call 1-800-752-9787
or Email-Inf[email protected]om

2

6
3
Site Location
Our exclusive leveling system was developed through more then 26
years of installation experience. This unique leveling system ensures
safe installation on un-level properties.
While your jungle gym will be level and safe some of the activities will be
affected by the sloping property (Diagram A ). If your swing beam is installed
downhill (or uphill), the swing position closest to the end will be lower to (or
further from the ground) (Diagrams A).
To determine play area size, it is recommended that you add six feet to the
jungle gym dimensions on all sides. However, besides swing beam side supports
and other low traffic areas it is not critical to have a six foot “play area”.
Installing a resilient surfacing under the jungle gym is always recommended and
can be done AFTER your jungle gym is installed.
A1
Level
Property Slope

4

Accessories Identification
5
1 @ SWING BEAM SBHG46120
Wood Identification Classic Swing
(2) (1) Tire Swivel
(1) Tire
(2) Easy 1-2-3 Bracket
(3) Snap Hooks
(3) Chains w/eye hooks

Hardware Identification
H6
B3
W3/8 W5/16
7
H6- 3/8” x 6 ½” Hex Bolt
B3- 5/16” x 3” Lag Bolt
N- Nut
W 3/8” Washer
W 5/16” Washer
N

7

8
Note: If you have purchased only the Eastern Jungle Gym hardware kit,
EJG recommends that the beam size should be 4x6x120”. The side
supports should be 4x4x96”.
Please prepare the swing beam using the dimensions shown in the
diagram below.
You will need a 1-3/8” x 8” Drill bit.
TIRE SWING
7/16” PILOT HOLE

Note: Make sure swing
hangers are facing up.
Step #1 Swing Beam Assembly Tire Swing
Place swing hangers on beam using hardware provided.
9
Step #2 Swing Beam Bracket Tire Swing
Layout SBHG46120 on the ground with swing brackets
facing up. Slide Easy 1-2-3 Bracket onto beam. Predrill
(3)-1/4” pilot holes. Attach bracket to post using B3 lag
bolts. Repeat on opposite sides.
3/8” Nut
3/8” washer