Easypix aquapix WDV1080 FULL HD Lagoon User manual

1

2
Introduction Of The Video Camera
1: LCD screen
2: Left/Mode button
3: Up/Playback button
4: Right/Self-timer button
5: OK/MENU button
6: Down/Delete button
7: Charging LED
8: Wrist strap eyelet
9: Shutter button
10: Power button
11: T button (zoom in)
12: W button (zoom out)
13: LED flash light On/Off button
14: AV out jack
15: USB port
16: Jacks cover
17: HDMI port

3
18: Jacks cover lock
19: Built-in speaker
20: Lens
21: Built-in microphone
22: LED flash light
23: Tripod socket
24: Battery cover
25: Battery cover lock

4
Preparation
1. Installing the battery
(a) Push the battery cover lock to the right to open the battery cover.
(b) Insert the battery into the battery compartment. Please have the metal
contacts aligned with the metal contacts in the compartment.
(c) After the battery is properly installed, close the battery cover until the
click sound is heard (if no click sound is heard, it shall mean that the
cover has not been properly closed).
2. Charging the battery
(a) Make sure the video camera is being switched off.
(b) Connect the video camera with the computer via the USB cable.
(c) The Charging LED will light in blue color white charging and will go off
when the charging is done.

5
Note:
It is normal that the temperature of the video camera body rises during
charging.
3. Inserting/removing the memory card
The camera accepts SD/SDHC card from 2GB to 32 GB. It is suggested to
use the memory cards with capacity more than 4GB and the speeds faster
than Class 4 to have the best performance for the 1080p video recording.
(a) Make sure the video camera is being
switched off.
(b) Push the battery cover lock to the right to
open the battery cover.
(c) Insert the memory card in the video camera
as illustrated.
(d) Place back the battery cover.
(e) To remove the memory card, please press
down the memory card until it pops up.
(f) Close the battery cover until the click sound is heard (if no click sound
is heard, it shall mean that the cover has not been properly closed).
1. Switching on/off the video camera
(a) Slide open the LCD screen and the video camera will be switched on.
(b) Slide close the LCD screen will switch off the video camera
You can also press the power button to switch on/off the video camera.

6
Note:
In order to save the battery power, the video camera will automatically
switch off after the video camera is being idle for a certain period of time
according to the user’s setting (please refer to the “Setup menu”
2. Switching between working modes
There are three modes as in the following chart. Please press the
LEFT/MODE button to switch and select the preferred working mode.
Note:
If you would like to enter the Playback Mode to playback the stored photos,
movie clips and audio files, press the UP/PLAYBACK button to enter
playback mode.
Icon
Title
Description
Capture Mode
For taking photos.
Video Recording Mode
For recording video
clips.
Audio Recording Mode
For recording audio files.

7
1. Video Recording
(a) Switch on the video camera and the video camera will enter the video
recording mode ( ).
(b) Use the T or W button to adjust the zooming.
(c) Press the LED flash light On/Off button on the top side of the video
camera to activate or de-activate the LED flash light.
(d) Press the shutter button to start/end the recording.
Note:
!The recording will automatically stop when the memory is full.
!It is requested to use memory cards with capacity of 4GB or more and
the speeds faster than Class 4 for 1080p video recording. If “Slow
card” shows on the LCD screen, even when it is set at 1080p video
size, the video camera will downsize the video to 720p automatically.
After reaching a max. video recording time of 29 minutes the
camera will automatically stop. It can only be restarted manually.
2. Taking photos
(a) Switch on the video camera.
(b) Press the LEFT/MODE button to switch to the Capture Mode ( ).
(c) Use the T or W button to adjust the zooming.
(d) Press the LED flash light On/Off button on the top side of the video
camera to activate or de-activate the LED flash light.

8
(e) Hold the video camera steady and press the shutter button to take the
photo.
3. Recording audio
(a) Switch on the video camera.
(b) Press the LEFT/MODE button to switch to the Audio Recording Mode
( ).
(c) Press the shutter button to start the recording.
(d) Press the OK/MENU button to pause/resume the recording.
(e) Press the shutter button again to stop the recording.
Playback Mode
Press the UP/PLAYBACK button to enter the Playback Mode. Use the
LEFT or RIGHT button to playback the desired file.
1. Playback video clips
(a) Press the shutter button to start the playing or end the playing.
(b) Press the OK/MENU button can pause or resume the playing.
(c) Use the T or W button to adjust the sound volume.
2. Playback audio files
(a) Press the shutter button to start the playing or end the playing.
(b) Press the OK/MENU button can pause or resume the playing.

9
Technical Specifications
Sensor
CMOS
Display
1.77" TFT Color LCD
Focus range
Standard: 150cm ~ infinity
Aperture
F/2.8, f=5.3mm
Shutter
Electronic Shutter: 1/2 ~ 1/2000sec.
Resolution
Still Image:
[12M]: 4000x3000; [10M]: 3648X2736;
[9M]: 3456X2592; [8M]: 3264x2448;
[7M]: 3072X2304; [5M]: 2592x1944;
[3M]: 2048x1536; [2M]: 1600x1200;
[VGA]: 640x480
Video:
1080P:1920x1080; 720P:1280x720;
VGA: 640x480; QVGA: 320x240.
Sensitivity
Auto
White balance
Auto/Daylight/Cloudy/Fluorescent/Incandescent
Exposure control
-2EV to +2EV in 0.3/step
Continuous
shooting
Yes (five photos at one shutter release
Photo color
[Standard]/[Sepia]/[Monochrome]/[Vivid]
Self-timer
2 / 5 / 10 sec.
External storage
Supports SD/SDHC 2GB to 32GB

10
TV system
NTSC / PAL
Digital zoom
4X
Power Supply
Li-Ion Battery
Ambient
temperature
Operating: 0° C ~ 40° C
Storage: -20° ~ 60° C
Microphone
Built-in
Speaker
Built-in
Dimension
116.5x67x48mm
Weight
Approx. 215g excluding battery
Specifications are subject to change without prior notice.
Before using your camera in the water please verify that all lids and locks
are tightly closed and sealed.
After using the camera in water please let it dry.
The camera should not be exposed to high temperatures and humidity
differences to avoid condensation behind the lens.
Open the battery compartment only when the camera is dry.

11
DECLARATION OF CONFORMITY
easypix herebly declares that the product WDV1080 is in conformity to all
the essential requirements of Directive 1999/5/EC. The declaration of
conformity can be downloaded here:
http://www.easypix.info/download/pdf/doc_wdv1080.pdf
Only EU