Eclipse BISON User manual

PRODUCT ASSEMBLY
INSTRUCTIONS
Furndeco Limited (Company No. 11023736) t/a Eclipse Furniture, 2 Marconi Drive, Quedgeley, Gloucester GL2 2AH, VAT Reg No. 281 887 457
T01452 336 520 Weclipsefurniture.co.uk [e-mail]
BISON BAR HEIGHT TABLE BASE - 6 SEATER
ITEMS SUPPLIED IN BOX
A2x 167.5cm Side Rails
B2x 57.5cm Side Rails
C4x Legs
D2x 59.5cm Side Foot Rail
E1x 171cm Middle Foot Rail
F1x Support Foot
G16x M8 x 20 socket cap
screws
H16x M8 washers
I4x M8 x 20 socket
cap screws
J1x M8 40 socket buon
head screws
K4x M8 x 80 socket buon
head screws
A
C
B
F
D
EK
J
IG H

STEP 1 STEP 2
STEP 3 STEP 4
Furndeco Limited (Company No. 11023736) t/a Eclipse Furniture, 2 Marconi Drive, Quedgeley, Gloucester GL2 2AH, VAT Reg No. 281 887 457
T01452 336 520 Weclipsefurniture.co.uk [e-mail]
Using the side rails (A B) and the legs (C) assemble the table
frame using screws (G) and washer (H). Do not fully ghten
the screws at this stage and ensure the holes in the legs are
correctly aligned.
The middle foot rail (E) aaches to both of the side rails using
screws (I). Do not fully ghten the screws at this stage and
ensure the holes in the rails are correctly aligned.
Aach the support foot (F) to the centre of the middle foot
rail using screw (J). Then ghten all ngs to make sure the
table base is secure. If the base is being used on an uneven
surface adjust the feet to ensure the table does not wobble.
Then use the side foot rails (D) and aach to the lower secon
on both sets of legs using screws (K). Do not fully ghten
the screws at this stage and ensure the holes in the rails are
correctly aligned.