Ecolab DPP-450 User manual

PestService DPP-450 Printer Quick Start Guide
1. CHARGE BATTERY
•Connect the power adapter for at least 4 hours
2. LOAD PAPER
•Turn the printer OFF
•Open the paper door by pressing the Paper Cover Release button on the
top cover
•Place the paper supply roll into the paper supply well.
•Make sure the paper unwinds from the bottom, and 2-3 inches of
paper extends beyond the top of the well
•Close paper door and press firmly until it clicks
•Turn the printer ON
•Verify that the paper advances correctly by pressing the Paper Feed
button
3. CONNECT OR RECONNECT PRINTER TO PESTSERVICE
This is a one-time setup, after which your iPhone will connect to your printer
automatically.
•Ensure that you have closed out of Pest Service FIRST
•Double Tap the Home button
•Swipe UP on Pest Service
•This closes out the app
•Ensure the printer is ON
•From your iPhone, tap ‘Settings’
•Within Settings, tap ‘Bluetooth’ and slide it on
•Select DPP-450 from list under ‘My Devices’
•A pop-up will display, tap ‘Pair’
•During your next service, when it is time to print,
select the DPP-450 printer from ‘Print Options’
DPP-450
Paper Cover Latch
Paper Cover
USB Port
Charging Jack
Battery
Paper Feed
Button
Print Button
Paper Cover
Release Button
USB Port
Charging Jack
Power Button

LED Color Status
CHARGE GREEN Steady Steady indicates battery is charged
Flashing Flashing indicates battery is charging
STATUS
NO COLOR Off Off indicates printer is ready
RED Steady Steady indicates paper is empty
Flashing Flashing indicates an error
PestService DPP-450 Printer Quick Start Guide
©2016 Ecolab USA Inc. All rights reserved. 03/16