ECOLOCITY LC-KL-SENS-1 Instruction Manual

IR Sensor Switch for LED Strip Light Channels
SKU: LC-KL-SENS-1 LC-KL-SENS-1D
EcolocityLED.com
[e-mail]
775-636-6060
Product SKU :
Product Size :
Input Voltage :
Max Load :





Warranty Period :
LC-KL-SENS-1
LC-KL-SENS-1D (DIM)
1.57" x 0.47" x 0.47"H



-4° ~ 149°F
5-100%

Dry

Input Power: 12VDC Constant Voltage
Controller Max Load
X * Y < 36 Was
X = linear strip light footage
Y = strip light was per foot


255 Distribution Dr. #104
Sparks, NV 89441, USA
ECOLOCITYLED.COM
775-636-6060
!
12VDC12VDC
3M VHB
3M VHB
3M VHB
3M VHB
3M VHB
3M VHB
3M VHB
3M VHB
120VAC
Use 12VDC Input Only!
DO NOT use AC Input!
WARNING – This product should be
installed, cut and connected only by a

This product is not designed to be
installed in wet or damp environ-

NEVER cut, connect, or join wires
while product is connected to a live

DO NOT bend or crease the strip in a
manner that will damage the conduc-


DO NOT use in environments over


DO NOT expose soldered connections!
BE CERTAIN your 12VDC source and

+
-
+
-
DC- LED OUT
DC+ LED OUT
** CONNECTIONS MUST BE SOLDERED BY THE END USER **
DC- INPUT
DC+ INPUT
(see installation instruction)
DIM

EcolocityLED.com
[e-mail]
775-636-6060
IR Sensor Switch for LED Strip Light Channels
SKU: LC-KL-SENS-1

pg. 2 of 2
1.) Tin Input Connections



2.) Tin Lead Wire



3.) Solder Lead Wire


input.
4.) Tin LED Strip Light



5.) Solder Strip Light



6.) Prep End Cap & Cover



7.) Adhere to Channel



8.) Press on Cover



9.) Apply 12VDC Power



10.) Wave 1-4” from Sensor


