Edge Commercial UVC Sterilizer User manual

INTERIOR AND
EXTERIOR USE
SAVE ECO LONG
LIFE
EASY
INSTALL
SARIN Energy.com
855-997-2746
LED@ SARIN Energy.com
Commercial UVC Sterilizer
Portable 253.7 nm Ultraviolet Disinfection
Kills Viruses, Bacteria, Fungi & More

Commercial UVC Sterilizer
Disinfect in 15-60 min
550 ft 2
(Maximum Eective Range)
550 ft 2
(Maximum Eective Range)
The Centers for Disease Control and Prevention (CDC) recommends a UV lamp intensity of 40 µW/cm 2
at the center of the work area to ensure surface decontamination.
317-548-5355
[email protected]
esgLED.com

Rapid Handheld UVC Sanitizer Wands
Commercial UVC Sterilizer
Viruses
Bacteria
Fungi
Mold
Yeast
Algae
Amoebas
Allergens
UVC Kills
21.6”
7”
Remote
PMMA
Touch Panel
Mercury
Quartz Lamp
Aluminum
Housing
360°
Motion
Sensor
317-548-5355
[email protected]
esgLED.com

Commercial UVC Sterilizer
Model: Commercial UVC Sterilizer
Size: 21.6”(L) x 7”(W) x 7”(D)
Power: 55 W
Voltage: AC90 - 100V
UV Strength: ≥117 µW /cm 2
UVC Wavelength: 253.7 nm
UVC Lamp: Mercury Quartz
Bonus Features: Motion Detector, Remote
Bulb Lifespan: ≥8,000 hours
Weight: 2.9 lbs
Certications: CE, RoHS (ETL, FCC Pending)
Plug in the device and place it in the center of the room about 40” away from the ground.
Make sure the area is clear and estimate the size of the room to determine cycle length.
FEATURES
SPECIFICATIONS
INSTRUCTIONS
TIPS & SAFETY
• To maximize eectiveness, ensure the
room to be disinfected is clear of debris
• Take care to avoid direct or prolonged
exposure of UVC to skin and eyes
• Keep out of reach of children and pets,
do not leave unattended while not in use
• Clear area of people, plants and animals
• Can be used near food, tests have not
shown any loss in quality or nutrition
• Set on a small stand like a tripod
• If the lamp breaks use a wet paper
towel to clean up, and do not inhale
• As distance from a subject is increased,
exposure time should be prolonged
1. Clinically proven to eliminate 99.9% of all viruses, bacteria, fungi, mold, yeast, algae,
amoebas, and other germs and allergens within seconds of 253.7 nm UVC exposure.
2. Can be programmed and set with touch panel or remote control.
3. A 360° motion sensor deactivates the lamp when it detects movement within 16 feet.
4. Contact-free disinfection reduces the chance of human error and cross-contamination.
5. Hypoallergenic sanitizing does not leave irritants or toxic chemicals behind.
6. Reduces the need to buy and handle corrosive cleaners. (Does not replace soap/water)
Area Disinfect Time
215 ft 215 minutes
320 ft 230 minutes
430 ft 245 minutes
550 ft 260 minutes
Manual Operation:
1. Plug in and power on.
2. Press ON/OFF button on
touch panel.
3. Using the Time Setting
button select your duration.
4. There is a 10 second delay,
then the light activates.
Remote Operation:
1. Plug in and power on.
2. Press ON/OFF button on
the remote control.
3. Select your duration using
a Time Setting button.
4. There is a 10 second delay,
then the light activates.
Motion Sensor: This activates 20 seconds after the lamp is switched on. When motion is
detected the light will turn o, then turn back on after 20 seconds of no motion. To activate or
deactivate the sensor, hold down a time setting button for 5 seconds.
317-548-5355
[email protected]
esgLED.com