EGS SOLA/HEVI-DUTY SDU-PMBRK User manual

Technical Services
U.S.A................................................................ [phone]
International………………………………………[phone]
www.solaheviduty.com
While every precaution has been taken to ensure accuracy and
completeness in this manual, Sola/Hevi-Duty assumes no
responsibility, and disclaims all liability for damages resulting from
use of this information or for any errors or omissions.
© 2005 Sola/Hevi-Duty. All rights reserved throughout
the world. Specifications are subject to change with-
out notice.
® Sola/Hevi-Duty name and logo are registered trade-
marks of EGS Electrical Group, LLC. All names
referred to are
trademarks or registered trademarks of their
respective owners.
272-38176-12
Rev.5 August05
R
EA
LR A
C
Y-
D U
DS
w
2 h
sa s
r
e
of h
c
ae
r
rc
s ew
)4
petS(
3 petS
()
S O L A
Industrial UPS
Surge Protection
IN
OUT
Figure 3: Partial front view and right-side view of SDU UPS with
mounting brackets and dry contact relay box.
Mounting Brackets
Instruction Sheet
SDU-PMBRK
Important!
Read the installation instructions carefully before
starting the assembly process.

What’s Included
• Two brackets (see Figure 1)
• Six M3 screws
• Seven washers #6
Assembly of the Mounting Brackets
Step 1: Determine which one of the two installation options to
be used as shown in Figure 2A:
• Installation Option A: Brackets installed facing
outward for easier access to the mounting holes.
• Installation Option B: Brackets installed facing
inward for a smaller footprint.
Step 2: Use 3 screws along with 3 washers to mount each
bracket on each side of the SDU UPS as illustrated
in Figure 2B.
Assembly of the Mounting Brackets and the
Dry Contact Relay Box
Step 1: Determine which assembly option is to be used (Option A or
Option B) as shown in Figure 2A.
Step 2: Use 3 screws along with 3 washers to mount the left side
bracket to the SDU UPS as illustrated in Figure 2B.
Step 3: Use 2 screws to mount the right side of the Dry Contact Relay
Box and the bracket into the right side of the UPS as illustrated
in Figure 3.
Step 4: Use 2 washers under the Dry Relay Contact Box for each of
the two screws used to secure the left side of the box as illus-
trated in Figure 3.
Notes:
• The 4 screws used for mounting the brackets to the Chassis (wall)
are not provided. The diameter of the hole is 0.219 in.
• The mounting brackets are used in conjunction with or
without the Din Rail mounting mechanism.
Figure 1: Front and upper side views of the Mounting Brackets
Figure 2A: Front view of the SDU UPS with mounting brackets
O
p
B noit
POWER ON / OFF / TEST
BATTERY WARNING /
ON BATTERY (BACK UP MODE)
AC INPUT NORMAL (AC MODE)
Input:
N L N
Output:
L
OVERLOAD
Re
mote
Circuit Breaker
Vout
IN
Surge Protection
OUT
S O L A
Industrial UPS
O
p
noi
t
A
Figure 2B: Side view of SDU UPS with mounting brackets