Anthro ERGOTRON Monitor Easy Track 835-MET User manual

WELCOME
Hello! Thank you for choosing Anthro.
These instructions describe the
installation of Anthro's Monitor Easy
Track.
TOOLS
You will need a 17/64" drill bit and
power drill.
PARTS LIST
Before beginning this assembly, please take a moment to
review the parts list below to verify that your shipment is
complete. The mounting surface (shown shaded) is not
included with this accessory.
1
Product Quantity Part Number
011 Monitor Easy Track 1 835-MET
02 Nylock Nuts 4 325-5259-00
03 Button Head Screws 4 325-5034-00
04 Washers 8 325-5120-00
ASSEMBLY INSTRUCTIONS
Monitor Easy Track®
01
02
03
04
Part Number: METBK
300-5635-00 rev. B • /
Built with Anthro-DNA™
For local customer care phone numbers visit: http://contact.ergotron.com
For Service visit: www.ergotron.com
For Warranty visit: www.ergotron.com/warranty

STEP 1
Place the Monitor Easy Track on Your Work
Surface
Clear o installation site so you can access the top and bottom
of the work surface.
Remove the Monitor Easy Track from the box. With the
assistance of another person, lift and place it on the work
surface (A). The gray handle must face the user. With the unit
closed (the boom will be furthest away from the user), position
it where you want the track mounted to the surface.
Without moving the unit base, open up the Monitor Easy Track
by squeezing the handle and pull the boom toward you. Once
the unit is in the open position, locate the 4 mounting holes in
the base that will be exposed (B). Use a pen or pencil to mark
the 4 holes where you will be drilling.
STEP 2
Drill holes in Your Work Surface
Close the Monitor Easy Track and remove it from the surface
with the assistance of another person. Gently place it aside
and out of the way. Using a 17/64" drill bit, carefully drill
straight down and all the way through the surface. Continue
with drilling all 4 holes.
STEP 3
Attach the Monitor Easy Track to Your Work
Surface
Once holes are drilled, be sure the drilled holes and surface
are cleared of debris. Place the Monitor Easy Track back onto
the surface with the assistance of another person. Open the
Monitor Easy Track by squeezing the handle and moving the
boom toward you.
Line up the holes on the unit base with the holes that you
drilled. Place a washer onto the screw, put the screw and
washer through the rst hole from the top of the surface. Place
a second washer onto the screw from the underside of the
surface. (For best results, this will require you to work beneath
the work surface.) Secure with a Nylock nut and tighten onto
the screw using a 5/32 hex driver and a 7/16 nut driver. (This
works best having someone hold the hex driver in place while
the other person is below the desk tightening the Nylock nut.)
Repeat this process for the remaining 3 holes.
B
A
Mounting Holes
Handle
Handle
Nylock Nut
Washer
Washer
Screw
17/64" Drill Bit
2” Button-head Screw
325-5034-00
Handle
1/4-20 Nylock Nuts
325-5259-00
Boom
Boom
Boom
300-5635-00 rev. B • /
© 2018 Ergotron, Inc. All rights reserved.
All trademarks are the property of their respective companies.
Anthro is a registered trademark and brand of Ergotron Inc.
Anthro-DNA is a trademark of Ergotron Inc.