EGS Sola Hevi-Duty S1K Series User manual

Technical Services
U.S.A................................................................ [phone]
International………………………………………[phone]
www.solaheviduty.com
While every precaution has been taken to ensure accuracy
and completeness in this manual, Sola/Hevi-Duty assumes no
responsibility, and disclaims all liability for damages resulting from
use of this information or for any errors or omissions.
© 2004 Sola/Hevi-Duty. All rights reserved throughout the
world. Speci cations are subject to change without notice.
® Sola/Hevi-Duty name and logo are registered trademarks
of EGS Electrical Group, LLC. All names referred to are
trademarks or registered trademarks of their respective
owners.
12.20.04 Rev. 1
S1K UPS Wall Mount
Bracket Kit
Off-Line UPS
320VA - 1200VA (115V)
Mounting Instructions

This bracket allows the S1K UPS series (320VA – 1200VA) to be mounted
to the wall/panel. One bracket kit is required for each UPS. The hardware
necessary for mounting the bracket is supplied. Each kit includes the
following:
1
Metallic Wall Mounting Bracket
4
Rubber Spacer Blocks
4 Screws
The bottom two provided screws should be
mounted 5.14” apart.
mounted 5.14” apart.
Af x the 4 rubber spacer blocks to the side of the UPS
adjacent to the wall, to prevent the UPS from sliding
out of position, as shown in step 2  gure. Place the
bracket on the UPS as shown, push and secure with
the 2 bottom screws.
the 2 bottom screws.
Secure the top of the bracket with the provided two
screws included in the kit.
Tighten all 4 screws and make sure the bracket and
the UPS are secure.
Step 1:
Step 2:
Step 3:
Step 4:
Step-by-Step Wall Mounting Instructions
5.14”
7”
Side View
Side View
Side View
Side View
Side View