CyberPower Paragon UPS Parts list manual

Status Information Card
Paragon
Series

2 Status Information Card
Installation
❑Switch off the Paragon UPS using the “on/off” button located on the front panel of the unit (see the
Paragon Series User Manual).
❑Disconnect from the power supply.
❑Unscrew the communication card cover at the rear of the unit.
❑The default pin settings can be modified (optional pinout configuration procedure):
- pin 2: used for the “replace battery” signal in the default configuration, but can be reconfigured for the
“emergency off” command.
- pin 5: provides a common electrical reference for all signals. Connected to 0-volts in the default
configuration but can be reconfigured for volt-free contacts.
(See “configuring pins 2 and 3” below for further information on modifying the default configuration.)
- Insert the status information card.
- Secure the card with the screws.
Functions
This relay card provides you with a simple means of transmitting data to a management system, a PLC, or a
computer system, using a 9-pin connector with the following pinout:
❑Pin 1: chassis ground.
❑Pin 2: contact closed when the battery must be
replaced.
A battery test is performed when the UPS is first powered on,
then again weekly (adjustable with UPS Driver). If a battery fault
is detected, the contact closes.
❑Pin 4: contact open when operating on battery supply.
❑Pin 5: common electrical reference for all signals (0V).
❑Pin 6: contact closed when operating on automatic bypass.
❑Pin 7: contact closed when a “low battery” warning is received.
❑Pin 8: contact closed when your application is powered via a UPS.
❑Pin 9: contact closed when operating on battery supply.
Status Information Card
12345
9876
OV
no nc no no no no
Relay breaking capacity:
Vmax = 25V DC
Imax = 1A
no = normally open
nc = normally closed

Status Information Card 3
Configuring pins 2 and 5 (optional)
Possible settings:
Standard settings: Replace battery and common electrical reference at 0V.
Customer settings: Replace battery and volt-free contacts.
Customer setting: Emergency Power Off (EPO).
JP01 BATT.FAIL JP02 EPO JP03 GND JP04
Connected Connected Removed Connected
Comments
• Pin 2 delivers the “replace battery” signal.
• Pin 5 is referenced to 0V.
JP01 BATT.FAIL JP02 EPO JP03 GND JP04
Connected Connected Removed Removed
Comments
• Pin 2 delivers the “replace battery” signal.
• Pin 5 is volt-free.
JP01 BATT.FAIL JP02 EPO JP03 GND JP04
Removed Removed Connected Connected
Comments
• Pins 2 and 5 receive the customer “Emergency Power Off” command: S1 wiring, max.
length 10m, see diagram below (pin 5 remains connected to 0V).
• Opening of external contact S1 immediately shuts the Paragon UPS off.
• The “Emergency Power Off” configuration only
works if pin 5 remains connected to 0V.
• Remote EPO switch wiring must be 10m maximum.
1234
S1
5
9876
External emergency
power off contact.

Paragon Series
Status Information Card