einrichten design buro forum ET223 User manual

Bueroforum planen und einrichten GmbH
Email: [email protected]
Tel: [phone]
Address:Edith-Stein-Strasse 3
97084 Wuerzburg Germany
Bottom introduction: There are seven buttons that "▲" , "▼" ,
"1" , "2" , "3" , "4" , "M"
(1) "▲" : Adjust the desk upwards
(2) "▼" : Adjust the desk downwards
(3) "1" : Position 1, first height position saved by the user
(4) "2" : Position 2, second height position saved by the user
(5) "3" : Position 3, third height position saved by the user
(6) "4" : Position 4, fourth height position saved by the user
(7) "M” : Height memory function
Height Adjustable Function:
Press the"▲" or "▼" button to adjust the height. The LED display shows the current height.
Height Memory Function:
a. Press UP or DOWN button and adjust the height to the desired height. Press "M" to save the height, and the
screen will display " ";
Press "1" , "2" "3", or "4" then, that is, save the height to the corresponding position 1 or 2 or 3 or 4, which will
show in the display screen as " " ," ", " " or " ";
b. Press "1", "2" , "3" or "4" button directly to automatically adjust the memory height you saved.
Anti-collision sensitivity adjustment - optional features:
a. Press and hold the “▲” “▼” button for 5 seconds at the same time to switch the sensitivity. Switch one file for
1 time and divide it into 4 files (A-3, A-2, A-1, A-0);
b. The display shows “ ” , the anti-collision function is off; the display shows “ ”, low sensitivity; Display
shows “ ”, medium sensitivity; display shows“ ”, high sensitivity; (factory default is A-3);
c. During height adjustment, when tabletop comes in contact with another object, it instantly stops and reverses
to avoid damage.
d. Press and hold the “▲” “▼” button for 5 seconds at the same time. If the display does not display the above
code, there is no anti-collision function.
Troubleshooting:
a. Reset: When the LED shows" " , press “▼” button until the desk reaches its lowest height and rebounds to
stop, it means the reset has been finished.
b. When it does't work and the LED shows "E01" or "E02", please retry 18 mins later.
c. If the “▼” button does't work, please check the cable connection and then cut off thepower for at least 10
seconds. Reconnect to the power and press “▼” button to start the reset process when it shows the " ".
d. If all these above process are inefficient, plz contact our customer service.