ELAN Lighting ARC33-S-IP User manual

ARC33-S-IP
Thank you for purchasing the ARC33-S-IP. Every suit has been thoroughly tested and
shipped in perfect condition. Carefully check the shipping carton for damage that may have
occurred during shipping. If the carton appears to be damaged, carefully inspect your unit for
any damage and be sure all accessories necessary to operate the unit has arrived intactly.
In the case damage has been found or parts are missing, please contact Acson Comercial
or your local supplier for further instructions. Do not return this unit without any warning.
USER’S MANUAL

2
Contents
FOR YOUR OWN SAFETY, PLEASE READ
THIS USER MANUAL CAREFULLY BEFORE
POWERING OR INSTALLING. SAVE IT FOR
FUTURE REFERENCE
1.Features .............................................................................................................. 3
2. Wiring System ................................................................................................... 3
2.1: 24VDC synchronous RGB tting
RGB: product circuit (5 cable)
3. Specications .................................................................................................... 4
3.1: Material Specications
3.2 Electrical Parameters

3
1. Features
• The ARC33-S-IP is a high power LED garden spot light with optional RGB color (with an added RGB controller).
• The standard input voltage is 24VDC. When you install the product, please check the data label on the product
and the wire.
• When using low voltage light xture, make sure you prepare a powerful power supply or 24VDC output transfor-
mer. Total demand of power is proportional to total power consumption + total power of cable impedance con-
sumption. When installing, always work with a skilled technician or contact your dealer’s customer service.
• The main material of this product is aluminum. Surface coating is only suitable for natural environments. Don not
install this product near the sea water o somewhere where the environment is highly salty o acidic.
• This is an IP65 grade product. Do not submerge xture into water.
• Aplicable environment temprerature: -20ºC < xture < +40ºC
Note: The drawing to the left
shows a general introduction
to this product. If there is any
discrepancy, please contact
your local supplier.
2. Wiring Diagram
2.1: 24VDC synchronous RGB tting
• The LED light source can create three colours of red, green, blue (RGB) at the same time, and create synchro-
nous RGB effects using a RGB controller.

4
• Housing - Aluminum anodized nshing & powder
painting
• Glass–Tempered glass.T=3mm
• Lens – Optical lens, efciency ≥ 85%
• Gasket – Tooling shaped seal
• Power Cable: H05RN-F x 0,5mm2 L=2m (for RGB)
• LED: TO type power LED for RGB
• Driver: Constant current output
• The three polarity wires represent the three colours of red, green, blue which feed the current for the individual
driver of tting, and control the colour changing program.
• Make sure the wires of each tting that represent the colour are connected in a same circuit, otherwise it can’t
create synchronous colour changing.
• The connection quantity can’t exceed the maximum load of the power supply. The recommended distance be-
tween tting and colour changing controller is less than 20m. The length of the RJ45 signal wire between the main
controller and the expander should be less than 50m.
3. Specications
3.1: Material Specications
3.2 Electrical Parameters
RGB: product circuit (5 cable)
B3AB0106 B3AM0106
Light Source 1×3W RGB 3in1 Full color 1×3W RGB 3in1 Full color
Lens B49 B49
Recommended selected lens degree 30 30
Input voltage (v) 24VDC 24VDC
Typical Operating Current (mA) R = 70 | G=70 | B=70 R = 70 | G=70 | B=70
Typical Consumption 5 5
Typical luminance (lm) 50 50
IK rate 02 02

Note: All information is subject to change without prior notice.
IMPORTANT INFORMATION!
In order to optimize the recovery and recycling of the materials that old appliances contain
and reduce the impact on human health and the environment, please make sure that this
product is recycled at the end of its life.
Importer:
ACSON COMERCIAL
C/Pallars, 405
08019 Barcelona
www.acson.com
[email protected]