
ELECTRO-METRICS LPA-30
(LPA30-1)
DESCRIPTION AND USE ELECTRO-METRICS
MODEL LPA-30 LOG PERIODIC ANTENNA
1.0 Description
The LPA-30 Log Periodic Antenna is a linearly polarized broadband antenna
designed to operate from 200 to 1000 MHz. The antenna is capable of operating as either
a transmitting or receiving antenna. The linearly polarized design permits separate
measurement of horizontal and vertical electric field components over its operating
frequency range.
The antenna is constructed of aluminum and phenolic with a Type N connector.
The antenna attaches to the Electro-Metrics Model TRI-136 Tripod using a derlin support
rod (supplied) equipped with an aluminum base (5/8-11 threaded female connector). This
allows the LPA-30 to be mounted at any point within a 90° arc in a horizontal plane. The
antenna is portable and suitable for use in applications where space is limited; e.g.
shielded rooms.
The antenna is calibrated at 1 and 3 meters with the calibration data included in
the manual as gain and antenna factors vs frequency. The LPA-30 can be used for Speci-
fication Compliance Testing and is suitable for susceptability testing. The antenna is
capable of handling up to a maximum power level of 1 kW.
NOTE: When performing measurements using the LPA-30
always include the level of attenuation within the
measurement system plus coaxial cable losses, in
addition to the actual antenna factors, for determining
the signal level being measured.
Table 1.0 gives the approximate power required when the LPA-30 Antenna is
used in radiated susceptibility testing. The power levels shown are based on the typical
gain of the antenna and do not include cable losses between the power source and antenna
terminals.
2.0 Specifications
2.1 Electrical
Frequency Range: 200 to 1000 MHz.
Input Impedance: Calibrated in a 50system.
Connector: Type N.
Average VSWR: Less than 2:1.