Electro-Voice ZX Series ZX1i Instruction manual

Weatherized Terminal Cover Kits
1. Remove the Nut on the outside of theTerminal Cover.
2. Thread the cable through the Nut and then the Gland and attach to terminals.
3. Remove the top 6 screws from input panel and attach Terminal Cover to speaker using screws supplied with the
Terminal Cover Kit.
4. Tighten the Nut to the Terminal Cover to form a seal around the cable.
Note: In order to form a liquid-tight seal, the cable must have a single, round, cross-sectional jacket. The
diameter of the cable must be between .17 in. (4.32 mm) and .395 in. (10.03 mm). If the diameter of the
cable is larger than .25 in., remove the rubber insert within the gland.
TC-ZX1i Terminal Cover
Assembly and Installation Instructions
ledoM.oN.taCnoitpircseD
i1XZ-CT100-559103 -metsySrekaepSi1XZrofrevoclanimretdezirehtaeW
kcalB
Wi1XZ-CT200-559103 -metsySrekaepSi1XZrofrevoclanimretdezirehtaeW
etihW
U.S.A. and Canada only. For customer orders, contact Customer Service at:
800/392-3497 Fax: [phone]
Europe,Africa, and Middle East only. For customer orders, contact Customer Service at:
+ 49 9421-706 0 Fax: + 49 9421-706 265
Other International locations. For customer orders, contact Customer Service at:
+ 1 952 884-4051 Fax: + 1 952 887-9212
For warranty repair or service information, contact the Service Repair department at:
800/685-2606
For technical assistance, contact Technical Support at: 866/78AUDIO
Specifications subject to change without notice.
12000 PortlandAvenue South, Burnsville, MN 55337
Phone:[phone], Fax: [phone]
www.electrovoice.com
© Telex Communications, Inc. 10/2005
Part Number 38110-516 Rev 1
Terminal Cover
with Gland Nut
facing down
Screws Torqued
to 10-15 in-lbs
(x6)
ZX1i Enclosure