INSTALLATION
WARNING!
Refer to "Safety information" chap-
ter.
INSTALLATION
WARNING!
Read and follow the instructions
carefully. There is a risk of injury or
damage to the appliance.
• Make sure that the appliance is not dam-
aged because of transportation. Do not
connect a damaged appliance. If it is
necessary, speak to the supplier.
•Installation and connection of the
appliance to the power supply must
only be done by qualified personnel.
• Only use built-in appliances after you as-
semble the appliance into correct built-in
units and work surfaces that obey the
standards.
• Do not change the specifications or
modify this product. There is a risk of in-
jury or damage to the appliance.
• Fully obey the laws, ordinances, direc-
tives and standards in force in the coun-
try where you use the appliance (safety
regulations, recycling regulations, electri-
cal safety rules etc.).
• Keep the minimum distances to other
appliances and units.
• Install anti-shock protection, for example
install the drawers only with a protective
panel directly below the appliance.
• If the fixing bracket is near to the terminal
block, always make sure the connection
cable does not come in contact with the
edge of the bracket.
• Prevent damage of the cut surfaces of
the worktop against moisture with a cor-
rect sealant!
• Seal the appliance to the worktop with
no space left with a correct sealant.
• Prevent damage of the bottom of the ap-
pliance from steam and moisture, e.g.
from a dishwasher or oven.
• Do not install the appliance adjacent to
doors and below windows. Hot cook-
ware can be hit off the hob when you
open doors or windows.
•Disconnect the appliance from the
electrical supply, before you do
maintenance work or cleaning.
WARNING!
Risk of injury from electrical cur-
rent. Carefully obey the instructions
for electrical connections.
• The electrical mains terminal is live.
• Make the electrical mains terminal free of
voltage.
• Install correctly to give anti-shock pro-
tection.
• Loose and incorrect mains plug and
socket connections can make the termi-
nal become too hot.
• A qualified electrician must install the
clamping connections correctly.
• Use a strain relief clamp on cable.
• Use the correct mains connection cable
and replace the damaged mains cable
with the proper cable type. Speak to
your local Service Centre.
The appliance must have the electrical in-
stallation which lets you disconnect the ap-
pliance from the mains at all poles with a
contact opening width of minimum 3 mm.
You must have correct isolation devices:
line protecting cut-outs, fuses (screw type
fuses removed from the holder), ground
leakage trips and contactors.
The manufacturer is not responsible
for any injury to persons and pets or
damage to property caused by failure
to obey these requirements.
ELECTRICAL CONNECTION
• Ground the appliance according to safe-
ty precautions.
• Make sure that the rated voltage and
type of power on the rating plate agree
with the voltage and the power of the lo-
cal power supply.
• This appliance is supplied with a mains
cable. It has to be supplied with a cor-
rect plug, able to support the load
marked on the rating plate. The plug has
to be fitted in a correct socket.
• Any electrical component must be instal-
led or replaced by the Service Force
ENGLISH 11