Electrolux EVY 9741 AAX Operating instructions

2. Remove the metal ring and clean the
glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Attach the metal ring to the glass
cover.
5. Install the glass cover.
The side lamp
1. Remove the left shelf support to get
access to the lamp.
2. Use a Torx 20 screwdriver to remove
the cover.
3. Remove and clean the metal frame
and the seal.
4. Replace the lamp with a suitable 300
°C heat-resistant lamp.
5. Install the metal frame and the seal.
Tighten the screws.
6. Install the left shelf support.
TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
1 What to do if...
Problem Possible cause Remedy
You cannot activate or op‐
erate the oven.
The oven is not connected
to an electrical supply or it
is connected incorrectly.
Check if the oven is cor‐
rectly connected to the
electrical supply (refer to
the connection diagram if
available).
The oven does not heat
up.
The oven is deactivated. Activate the oven.
The oven does not heat
up.
The clock is not set. Set the clock.
The oven does not heat
up.
The necessary settings are
not set.
Make sure that the settings
are correct.
www.electrolux.com

Problem Possible cause Remedy
The oven does not heat
up.
The automatic switch-off is
activated.
Refer to "Automatic switch-
off".
The oven does not heat
up.
The Child Lock is on. Refer to "Using the Child
Lock".
The oven does not heat
up.
The fuse is released. Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse releases
again and again, contact a
qualified electrician.
The lamp does not oper‐
ate.
The lamp is defective. Replace the lamp.
The display does not show
the time during the off sta‐
tus.
The display is deactivated. Touch and at the
same time to activate the
display again.
The core temperature sen‐
sor does not operate.
The plug of the core tem‐
perature sensor is not cor‐
rectly installed into the
socket.
Put the plug of the core
temperature sensor as far
as possible into the socket.
It takes too long to cook
the dishes or they cook too
quickly.
The temperature is too low
or too high.
Adjust the temperature if
necessary. Follow the ad‐
vice in the user manual.
Steam and condensation
settle on the food and in
the cavity of the oven.
You left the dish in the
oven for too long.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the
cooking process ends.
The display shows "C2". You want to start the De‐
frost function, but you did
not remove the core tem‐
perature sensor plug from
the socket.
Remove the core tempera‐
ture sensor plug from the
socket.
The display shows an error
code that is not in this ta‐
ble.
There is an electrical fault. • Deactivate the oven
with the house fuse or
the safety switch in the
fuse box and activate it
again.
•If the display shows the
error code again, con‐
tact the Customer Care
Department.
2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service
centre is on the rating plate. The rating
plate is on the front frame of the
appliance cavity. Do not remove the
rating plate from the appliance cavity.
ENGLISH 41