You must select this option after you have set
the programme and before you start the pro-
gramme.
You can cancel or modify the delay time at
any moment, before you press button 6 .
Selecting the delayed start:
1. Select the programme and the required
options.
2. Select the delay start by pressing the but-
ton 7 .
3. Press button 6 :
– the machine starts its hourly count-
down.
– The programme will start after the se-
lected delay has expired.
Cancelling the delayed start after having star-
ted the programme:
1. Set the washing machine to PAUSE by
pressing button 6 .
2. Press button 7 once, the light relevant to
the selected delay goes off
3. Press button 6 again to start the pro-
gramme.
The Delay Start can not be selected with
DRAIN programme.
Important! The selected delay can be
changed only after selecting the washing
programme again.
The door will be locked throughout the delay
time. If you need to open the door, you must
set the machine to PAUSE (by pressing the
button 6 ) and then wait a few minutes. After
you have closed the door, press the button
6 again.
Start the programme by pressing button
6
To start the selected programme, press the
button 6 , the corresponding green pilot light
stops blinking. The pilot lights 8.1 and 8.2
illuminate to indicate that the appliance starts
operating and the door is locked.
To interrupt a programme which is running,
press the button 6 : the corresponding green
pilot light starts blinking.
To restart the programme from the point at
which it was interrupted, press the button 6
again . If you have chosen a delayed start,
the machine will begin the countdown.
If an incorrect option is selected, the red pilot
light of the button 6 blinks for 3 times.
Altering an option or a running
programme
It is possible to change some options before
the programme carries them out.
Before you make any change, you must
PAUSE the appliance by pressing the button
6 .
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to O and then to the new pro-
gramme position. Start the new programme
by pressing the button 6 again. The washing
water in the tub will be not emptied out.
Interrupting a programme
Press the button 6 to interrupt a programme
which is running, the corresponding green
pilot light starts blinking.
Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to to cancel a pro-
gramme which is running.
You can select now a new programme.
Opening the door
After the programme has started (or during
the delay time) the door is locked, if you need
to open it, set first the machine to PAUSE by
pressing the button 6 . After a few minutes
the light 8.2 goes out and it is possible to
open the door.
If this light remains lit and the door is locked,
this means that the machine is already heat-
ing or that the water level is too high. In any
case, do not try to force the door!
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to O . After a few mi-
nutes the door can be opened (pay atten-
tion to the water level and tempera-
ture!) .
After closing the door, it is necessary to se-
lect the programme and options again and to
press button 6 .
At the end of the programme
The machine stops automatically. The pilot
light of button 6 , the pilot lights 8.1 and
8.2 go off. The light 8.3 illuminates.
If a programme or an option that ends with
water left in the tub has been selected, the
pilot light 8.2 remains on and the door is
electrolux 9