Elerillo 2243 User manual
Installation Method
Connect the wire
Cover Removal
Unit installation
3
Ou
ter Cover
R
e
-
installation
Test Run
Once the unit has been firmly
fixed to the wall, ensure there
is no movement or vibration.
The unit is installed firmly
without any movement.
Please use the rated voltage
Confirm the power and
voltage
3
Switch on the power
Close external power supply
switch or insert the power
plugs
The motor will be activated
and the air will blow out
Place your hands
underneath the drying
to activate drying.
Daily Use and Maintenance
External Maintenance
/
There will be noticeable
movement/vibrations,
causing excessive noise.
If the power use is incorrect, it
will cause an electrical surge,
or the unit to burn out.
The power socket must be
compatible with the unit's
plug. Should it not be
compatible, the sensor light
will display dim.
Should the drying not activate,
ensure your hands are close
enough to the dryer for the
sensor to dedect motion.
R
Sensing
device
Elerillo Stainless Steel Hand Dryer
I 2243
User Manual
U
V
B
M
U
T
echnical Specications
WARNING
Do not let children improperly operate
or misuse the unit.
Do not open the front panel, as this may cause an electrical shock risk.
: • Do not splash or spray water/liquids in front of the unit. As it may cause an electric shock risk. The
IP13 rating means that it must be at least 60cm away from a bath, sink, shower or water source.
0 • Do not use in a wet environment, where water may get directly into the unit or where
condensation may form. The unit is likely to malfunction in damp conditions.
0 ! • 'RQRWSHUIRUPXQQHFHVVDU\GLVDVVHPEOLQJ, as thisPD\FDXVHILUHKD]DUGVHOHFWULF
VKRFNDQGLQMXU\DFFLGHQWV
0
0
5DWHGSRZHULVUHTXLUHG
,ISRZHUWROHUDQFHLVRYHUWKHXQLWZLOOPDOIXQFWLRQ,ItheLQFRUUHFWSRZHUVXSSO\ is
used it may cause aILUH andHOHFWULFalVKRFNhazard, or cause thePDFKLQHto PDOIXQFWLRQ.
3OHDVHXVHGHGLFDWHGVRFNHW
If used in combination with other appliances, it may cause abnormal heat in the shunt outlet.
Power must be turned off during maintenance to prevent the risk of electric shock.
Air filter must be installed.
If the unit doesn't work or appears faulty, please turn off power to prevent accidents;
close the leakage circuit breaker and ask supplier to check and repair, as this may cause a
1ire hazard due to an electricity leakage and short circuit.
Unit must have reliable ground connection.
0 Attention when installing: Do not install when the unit is connected to a power source.
This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instructions concerning the safe use of the appliance by a qualified and experienced person.
Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children
without supervision.
If the cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
For additional protection, the installation of a residual current device (RCD) having a rated residual
operating current not exceeding 30mA is advisable in the electrical circuit supplying the bathroom. Ask
your installer for advice.
-
Parts
L
ist
Outer Cove
Electrical Diagram
Precautions before Installation
N
T
:
228.5MM
5MM
I
172MM
<
,
lj
12MM
219.5MM -�
hole of junction box
Floor without 10
real size of junction box)
22
T
Popular Dryer manuals by other brands
Hitachi
Hitachi TD-80YFE instruction manual
Samsung
Samsung DV365GTBGSF/AC user manual
MASTER KITCHEN
MASTER KITCHEN MKD FS608HP ED A++ owner's manual
Mitsubishi Electric
Mitsubishi Electric JT-S1AP-W-NA installation manual
Ingersoll-Rand
Ingersoll-Rand D127NC Operator's manual
Whirlpool
Whirlpool LE2OOOXS Use and care guide