emeco RUN User manual

RUN by SAM HECHT + KIM COLIN
emeco.net

emeco.net
1. POSITION THE FRAME UP RIGHT
2. UNFOLD THE FRAME
3. WHEN THE FRAME IS UNFOLDED,
EXTEND SIMILAR TO THIS IMAGE
PLANK “A”
PLACE THIS SIDE DOWN ONTO FRAME
PLANK “B”
PLACE THIS SIDE DOWN ONTO FRAME
1

6. PLACE PLANK “A” ON THE MIDDLE LEVEL AND ASSEMBLE 4 SCREWS
PLANK “A”
7. PLACE PLANK “B” ON EACH LEVEL AND ASSEMBLE 4 SCREWS FOR EACH PLANK
PLANK “B”
PLANK “B”
PLANK “B”
2
10. WITH THE 12 SCREWS TIGHTENED TURN THE SHELF BACK UPRIGHT

2 3
8. WITH THE PLANKS ALL ASSEMBLED TURN THE SHELF ONTO ITS SIDE FOR
THE 12 RECESSED SCREWS TO BE TIGHTENED IN 6 LOCATIONS
9. SHELF ON ITS SIDE FOR SCREWS TO BE TIGHTENED
3 LOCATIONS ON TOP
3 LOCATIONS ON TOP
TIGHTEN THESE 2 SCREWS IN 6 LOCATIONS
SEE DETAIL “A”
10. WITH THE 12 SCREWS TIGHTENED TURN THE SHELF BACK UPRIGHT