ENERGEN Power Jumper P4 Instruction Manual

Power Jumper P4
USER MANUAL AND SAFETY GUIDELINE

LED Flash Light
Intelligent Jump Clamp
Model : EN-PJP4WH / EN-PJP4BK
USB Charging Cable AC Adapter
Thank you for choosing Power Jumper.
Function Button
LED Display
Jump Clamp Socket
USB 5V 2.4A Output Port
15V 1A Input Port

B. Jump Start Procedure:
01.
02.
03.
04.
05.
06.
Securely connect the jump clamp to jump clamp socket.
3 seconds.
indicator of intelligent jump clamp will illuminate a solid green. It’s ready to
To turn on:

01.
02.
03.
Plug the USB charging cable to USB 5V/2.4A output port.
charging.
07.
08.
09.
①②③④⑤
LED
No Light:
No Light with Beep Sound:

Weight : 0.64LB / 290G
Model Number : EN-PJP4-BK / EN-PJP4-WH
: 10000mAh
: Cycles < 500
Outputs : USB 5V / 2.4A
Input : AC100-240V, DC15V / 1A
Jump Start Current : Peak 400A
Charging Time : Charging Times Approx. 2.5hrs
: -4°~140°F / -20°C - 60°C
LED Energy : 1W
Dimensions : 5.4 × 2.8 × 1.1 inch / 138 × 72 × 27 mm
E. Parts List:
1
1
1
1
1
Power Jumper
USB Charging Cable
AC Adapter
User Manual
Jump Clamps
Parts Name
1
2
3
4
5
﹟
D. Using LED Flash Light:

J. Warning
I. Toxic and Harmful Substances
Finding Cause
Connect the AC adapter
into 15V 1A input port to
reset.
No response when
pressing the FUNCTION
A. Approx. 1 hour.
01.
02.
03.
may cause danger.

Always be cautious when using Power Jumper and avoid operating
Power Jumper unattended. Please remain in constant observation
to monitor the charging process for any potential problems that may
occur.
The Power Jumper is not intended for use by children under 18
without adult supervision.
The Power Jumper is neither water-resistant nor water proof. Do not
splash, put in contact with or submerge in water.
Do not operate the Power Jumper near open flame, compressed
gas canisters or flammable liquids.
Do not open the chassis or disassemble the Power Jumper. Modifying
or tampering with Power Jumper’s internal components can cause a
malfunction and will void its warranty. If your Power Jumper is not
performing as it should, contact with our technical support for
assistance.
Keep the product away from extreme heat or cold.
Please avoid dropping, hitting or throwing the Power Jumper.
Do not store where the temperature may exceed 104°F.
Charge Power Jumper or only at ambient temperature between
23°F ~104°F
Under extreme conditions, battery leakage may occur. Carefully
wipe the liquid off by using a cloth and avoid skin contact when you
notice liquid on the batteries. In case of skin or eye contact, rinse
immediately with clean water and ask for medical attention.
At the end of its useful life, please properly discard the Power Jumper
according to your environmental regulations.

For any ques please t us online at www.myenergen.com.
and workmanship for a period of 12 months from the date of purchase by the end
replaced.
5. We do not assume responsibility for any loss or damage incurred during shipment
or as a result of a force majeure.
use or misuse of product.
becomes the property of us.
repaired or exchanged depending on the model. Please allow approximately 2
charge.
Table of contents
Popular Remote Starter manuals by other brands

ArnosMater
ArnosMater Jumps Power AMG15 quick start guide

CompuSTAR
CompuSTAR 2WFMRS user guide

ULTIMATE SPEED
ULTIMATE SPEED ULG 15 B4 Operation and safety notes

Autostart
Autostart as2520 installation guide

BOLTPOWER
BOLTPOWER G27 manual

Autostart
Autostart Two-way 6-Button LCD Automatic Transmission Remote Starter... user guide