enfig RMK-R8 User manual

1
Anappropriate installation inobservance ofthese operating instructions is necessary. Please make
sure the wiring is arranged so it is not bended or crimped due to the risk of cable break. Make sure that all
connections are correct. Route the cable away from moving parts, do not allow the cable to be entangled,
pinched or damaged in any way.
We will not be liable for damage due to improper installation or utilization. Use the specified accessory
parts to prevent product failure.
Subject to technical modifications; no responsibility is accepted for the accuracy of this information.
1. Face Plate
2 Right Mounting Bracket
3. Right mounting braket
4. Face Plate Bottom Support
5. Qty 2 M5X2 Screws
6. Radio mounting screws (supplied
with radio
Enfig RMK-R8 2008-2015 Audi R8

Installation Manual
2
Use 4 radio removal keys
to remove the radio.

3
Remove all the
factory
connections

Installation Manual
4
TX20
Remove the 3 circled T20
torx screws.

5

Installation Manual
6
Trim the corners of radio
cavity. It is recommended that
you use the radio mounted onto
the side brackets so you do not
cut too much.

7
Trim the area shown on the radio
surrount in order to make room
for the left mounting bracket.
This will be hidden by both the
factory and aftermarket radio.

Installation Manual
8
Attach the radio mounting brackets to your
radio using the screws supplied with the
radio.

9

Installation Manual
10
Trim off the part shown in
the image below.

11
TX20
Mount the (4)bottom support to the
car usiing the supplied (5) M5x12
screws.
4
5
Reinsert the one t20 torx
screws. The keep the
other two with the
factory radio.

Installation Manual
12